Red pointer alignment procedure
5
⑫.Take a look at the laser head’s location and verify that the red pointer is ON and hitting the engraving material
placed there.
⑬.Making sure the laser machine’s cover is closed, push the red pointer button for a while.
The red pointer should disappear and the laser beam should fire as long as the button is pushed.
⑭.2 seconds is typically long enough. (If not, keep pushed until a tiny mark is visible on the engraving medium).
The laser will cease firing and the red pointer should reappear as soon as the red pointer button is released.
⑮.Using the four arrow keys , precisely bring the red pointer on the centre of the burn mark.
⑯.Once centring is satisfying, press validate to register the new setting . The machine should emits a
acknowledging “beep” sound.
⑰.The alignment procedure is done. Exit the configuration menu by pressing the cancel key until getting
back to the “Gravograph” display.
Then wait for starting sequence to complete. Once “Ready to receive” displays, the machine is now ready to
use normally again.
