Green Brook DAT01A User manual

Dia. 3
Dia. 1 Dia. 2
1A Mains Trans ormer
INSTALLATION
Part Number: DAT01A
Use this transformer in conjunction
with the GreenBrook hardwired
doorchimes when you want to have
an illuminated doorpush.
•Use with illuminated doorpushes or
when converting a doorpush to an
illuminated push.
Please read the instructions fully
before attempting installation.
1. Remove cover screw A and
remove cover B and fix the
transformer base C in required
position via fixing holes D (see
Dia.1). It must be located in an
accessible position.
2. Connect mains cable to MAINS IN
terminals and secure cable to
prevent movement.
3. Connect the chime bellwire to the
8V terminals on the transformer
and terminals D & C on the
doorchime (see Dia. 3). This gives
the required 8V output.
4. Before replacing cover B, check
terminals to ensure that no strands
of wire are showing. Replace cover
B and screw A.
5. witch on power to transformer
and check operation.
Note: This transformer is for use with
doorchimes and door ushes.
This roduct should be installed by a
com etent erson and in accordance
with the current IET Wiring Regulations.
If in doubt, consult a qualified
electrician.
g
DAT01A ins May 17.qxp_DAT01 Manual 07/06/2017 15:01 Page 1

2
r
Issue no: 704826
GUARANTEE
Your GreenBrook 1A Transformer DAT01A is
guaranteed for 1 year from the date of urchase.
This is in addition to your statutory rights.
PLEASE KEEP THESE INSTRUCTIONS
SAFE FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
[e-mail]
www.greenbrook.co.uk
TECHNICAL INFORMATION
Rated Voltage: 220 ～240V 50Hz
Output Load: 4V, 8V or 12V, 1A
Dimensions: H76 x W54 x D41mm
Conforms To: B EN 60742,
EN 300220-3,
EN 301489-3 &
EN 60950-1
DAT01A ins May 17.qxp_DAT01 Manual 07/06/2017 15:01 Page 2