Griesser hand-held radio transmitter SFB-1M / SFB-5M
Safety Instructions
Observing the instructions is a prerequisite for safe and fault-free operation and for achieving the product characteristics.
lThe operator/user must have fully read and understood the instructions.
lThe operator must ensure that the instructions are available to the user in a readable form.
lThe operator must ensure that all safety measures are considered and observed.
lThe following safety and assembly instructions refer to the device and not to the accessories or drive.
BEWARE!
Non-observance may lead to injuries!
Observe all safety instructions!
lNever install or put damaged products into operation.
lOnly use unaltered and compatible original parts.
lIn the event of unauthorised opening, improper use, incorrect installation or incorrect operation of the device, there is a
risk of personal injury and damage to property.
lThe device contains parts that can be swallowed.
Risks for persons when handling the device
lChildren under the age of 3 or persons who cannot assess the risks are not allowed to use the device. Keep it out of
their reach.
lPackaging materials may not be used for playing.
Operation
lOnly use the device in dry rooms.
lIf the system is controlled by one or more transmitters, the motion of the system must be visible during operation.
lDispose of used batteries properly.
Safety instructions for radio operation
Observe all safety instructions for radio operation
Only use radio systems if they are permitted and can be operated in a fault-free manner
lRadio systems must not be operated in areas where there is an increased risk of interference (e.g. hospitals, airports).
lRemote control is only permitted for devices and systems where a malfunction in the transmitter or receiver does not
pose a risk to persons, animals or objects, or where this safety risk is covered by other safety devices.
lThe operator is not protected from interference from other telecommunications systems and terminal equipment (e.g.
from radio systems which are properly operated in the same frequency range).
lThe range of the radio signal is limited by law and the structural conditions.
Type plate
The type plate is located on the back of the hand-held transmitter.
Intended Use
The Griesser hand-held radio transmitter SFB-1M (1 channel) and SFB-5M (5 channel) are intended solely for controlling sun
protection systems such as external venetian blinds, roller shutters, facade awnings and awnings. The instructions for this hand-
held transmitter apply to Griesser blind actuators with a slot for an extension module and using a MOFUB radio module.
Operating instructions - Page 1
014162.710 / 1V0 / 03.05.2023 / EN Subject to change without notice
