GRIT Junior User manual

Have a question? Call 617-356-8106 or email suppor[email protected].
GRIT Junior: Anti-Tip Bars Installation Guide
1
Remove the nut and
washer from one of
the two rear seat
bolts. Keep the bolt in!
Just take off the nut
and washer.
2
Slide the Anti-Tip Bar
over the exposed bolt
thread. Tighten the
nut back onto the bolt.
Do not include the
washer!
Tools Required:
Large Phillips (cross-head) screwdriver, 13mm (or adjustable) wrench, 5mm hex key (came with your
Freedom Chair)
These Anti-Tip Bars help you ride securely by making it harder to tip the Freedom Chair backward. They
come pre-set in a safe riding position. You may adjust their length.
!
The Anti-Tip Bars cannot prevent every possible accident:
•You are responsible for your safety. Ride within your limits. If you feel unsafe, stop.
•Ride with a spotter behind your chair while getting used to the Freedom Chair and Anti-Tip Bars,
especially on ramps and uneven terrain.
•Do not build up backward momentum. Rolling backward on a ramp, even with Anti-Tip Bars
installed, is dangerous and could cause a fall.

3
Repeat the two
previous steps for the
other rear seat bolt
and Anti-Tip Bar.
The Anti-Tip Bars are shipped at GRIT’s recommended length. The length can be adjusted to
make the bars more secure or more permissive. To adjust the bar length:
• Use the 5mm hex key to loosen the clamps.
• If shortening the Anti-Tip Bars, slide the sliver bars off, and remove the spacer. Note that a
second spacer is included inside and is glued in. Do not remove this second spacer, as over-
shortening the bars will render them ineffective. With the second spacer inserted, the bars
are safe to use in most riding conditions.
• If lengthening the Anti-Tip Bars, slide the sliver bars to the desired length and tighten.
Additional spacers have been provided for your convenience, but are not required.
• Use the 5mm hex key to tighten the clamps. Make sure the bars are at the same length.