2
SAFETY INFORMATION
• Keep the work area clean and dry. Damp or
wet work areas can result in injury.
• Check for damaged parts and any other
conditions that may aect the operation of
this product.
• Do not use the lamp in the immediate vicinity
of inflammable materials or gases.
• Only use the accessories included with the
product.
• Keep the lamp out of reach of unauthorized
persons, especially children.
• Do not point the light directly in your own or
any other person’s or animal’s eyes.
• Do not attempt to open the battery
compartment.
PACKAGING CONTENT
DESCRIPTION QTY.
Light 1
100-240V AC Charger 1
12V DC Car Charger 1
NOMENCLATURE
REFERENCE NO. DESCRIPTION
1. Trigger
2. Trigger Lock
3. Lanyard
4. Whistle
INSTALLATION
Refer “NOMENCLATURE”
Before using:
1. Remove the orange insulator cap on the back
of the spotlight.
2. Charge the light completely before first use.
Charging:
1. Before charging, make sure the work light is
turned o.
2. Make sure that the trigger switch is not locked.
3. Remove the transparent protective cover on
the back of the spotlight.
4. Plug the AC Charger or 12V DC Car Charger
into the back of the spotlight.
5. LED Indicator will turn on while charging and
will turn o when fully charged.
6. Charging will take 4-5 hours.
Operation:
1ST
PRESS
2ND
PRESS
3RD PRESS 4TH PRESS
& HOLD
TYPE INTENSITY SOS
FLASHING
RED
FLASHING
HIGH LOW
LUMEN 700 350
RUN TIME 2 hrs 4.5 hrs
REPLACE DC PLUG FUSE
Step 1: Disconnect spotlight from power source
Step 2: Unscrew the cap of DC Plug and pull
straight away from fuse
Step 3: Pull fuse holder and fuse out of the DC
Plug
Step 4: Insert new fuse into the holder
Step 5: Insert fuse holder into lighter plug
Step 6: Screw cap onto lighter plug
Port
2
1
4
3
