INSTALLATION We do not recommend that you place the preamplifier
directly on top of the power supply. The length of the power
supply cords allows you to place the power supply some
distance away from the preamplifier. If you wish to place the
power supply beside the preamplifier we suggest that you
place it on the left side of the preamplifier where the risk of
electrical interference is at a minimum.
AC POWER The Elektra should ideally be connected to a separate AC
group independent of other equipment.
The Elektra is designed for use with a three-pin AC connector
with separate ground, but may in some countries be used
with alternative grounding. Your Gryphon dealer or importer
will give you further details
AC GROUNDING In order to utilize the AC filtering section of the amplifier,
connection to ground is essential. Generally, overall
performance can be greatly improved with proper
grounding. The degree of improvement will depend on local
conditions.
AC POWER CORDS Use only a dedicated AC power cord. Do NOT use
loudspeaker cable or other wire not expressly designed to
carry high current. Improper cable or cables of insufficient
gauge will generate heat and the insulation may melt with
disastrous results.
AC cords DO have an audible effect on sound quality, but
experiments should be carried out with due consideration to
safety.
AC CONDITIONERS ? The Elektra has its own built-in AC conditioner, if you use
external line conditioner or other devices, we strongly
recommend that you listen to the Elektra without these
devices before you make your decision.
Remember to listen for correct sound and not merely different
sound.
AC POLARITY Do not run long, thin, curled extension cords.
The Elektra is a true dual mono construction and we must
strongly emphasize the importance of symmetrical AC power
polarity for each channel. Asymmetrical AC polarity will
strongly degrade soundstage recreation and other important
aspects of the Elektra’s performance.
