GTO RB709-U User manual

RB709-U
Relay Output Universal Receiver
Owners Manual
The RB709-U digital receiver is a
wireless radio control designed for
use with automated gate openers
and garage door openers. The
receiver has two channels for re-
ceiving signals from two separate
transmitters.
www.gtoinc.com
Specifications
Compatible transmitter:
 •GTOnarrowbandtransmitters(318MHz)
Power input:
 •8-24Vac/dc,10mastandby,40maactivated(Red&Blackwires).
Outputs:2channelspulsedoutputs
 •2channelsdry-contactnormallyopenrelayoutputs.
 •Channel1:Blue&Greenwires.
 •Channel2:Yellow&Brownwires.
 •Activatedfor.5secondswhenthecorrecttransmittercodeisreceived.
 •Relayswitchingmaximumrating:24Vac/dc@1A.
 •OperatingRange50to100feet(15.2to30.5m)
Indoor/Outdoorcompatible.
Mounting the Receiver Connect Receiver to Relay Inputs and Power
Consider the following when mounting the receiver:
•Standardreceivercablelengthis10feet(3.05m).
•Forexteriorapplicationsrunthecablethrough
PVCconduittoprotectitfromdamage.
•DONOTruncableinconduitcontainingacwiring.
•Thereceiverrangecanvaryfrom50to100
feet(15.2to30.5m)dependinguponweather,
topography,andexternalinterference.
FCC Regulation
This device complies with FCC rules Part 15. Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept an interference that may cause undesired operation.
Transmitter distance may vary due to circumstances beyond our control. NOTE: The manufacturer
is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to operate the equipment.
NOTE: Do not mount upside down in exterior applications.
Channel 1 (GREEN WIRE to COM)
Channel 1 (BLUE WIRE to RELAY)
Channel 2 (BROWN WIRE to COM)
Channel 2 (YELLOW WIRE to RELAY)
2nd GATE OPERATOR or DOOR OPENER
1st GATE OPERATOR or DOOR OPENER
8 to 24 VOLT AC/DC
POWER SUPPLY
RED WIRE to POSITIVE
BLACK WIRE to NEGATIVE
RED
BLACK
GREEN
BLUE
BROWN
YELLOW
Designed to work with most brands of gate and
door openers.
GTOTechnicalSupport1-800-543-1236

Programming the Receiver
Wiring Receiver to Common Gate and Door Openers Wiring Receiver to GTO DC Operators
Wiring Receiver to GTO GP-SL100 & GP-SW100 Operators
Learningtransmitter(s)withRB-709Ureceiver:
• Pressandholdthetransmitter’sbuttontobelearned.
• Pressthe‘LEARNCH1’(or‘LEARNCH2’)buttonontheRB-709Ureceiverfor
1-2secondsoruntiltheredLEDturnson,thenreleasethebutton.
• Note:Whenthecorrectcodeisreceivedandthecorrespondingrelayoutput
isactivated,theredLEDwillturnon.
Channel 1 (GREEN WIRE to COM)
Channel 1 (BLUE WIRE to RELAY)
BLACK
RED
Channel 2 (BROWN WIRE to COM)
Channel 2 (YELLOW WIRE to RELAY)
ALARM
ACC.POWER DUAL CABLE
+12Vdc
COM
DUAL LINK
LINK COM
RELAY OUTPUTS
LOCK N.C.
LOCK COM
LOCK N.O.
RUN 1 RUN 2
CLOSED 1 CLOSED 2
CYCLE
SAFETY
OPEN EDGE
RUN 2
OPEN
CLOSE
STOP
COM COM COM
SHADOW
LOOP
Checkoperationafterprogramming:
• PressTransmitter#1-REDLEDblinksoncetoconrm.
• PressTransmitter#2-REDLEDblinkstwicetoconrm.
GTO/PROGP-SL100andGP-SW100ContolBoard
TypicalGTODCpoweredgateoperators.
GTO/PRO2000XL,3000XL.4000XL,andMightyMule500
6 5 4 3 2 1
Genie Garage Door Opener
CHANNEL 1 (COM)
CHANNEL 1 (NO)
Linear Garage Door Opener
PUSHBUTTON
COMMON
BEAM
ANTENNA
CHANNEL 1 (COM)
CHANNEL 1 (NO)
Lift Master
Garage Door Opener
CHANNEL 1 (COM)
CHANNEL 1 (NO)
Chamberlin
Garage Door Opener
CHANNEL 1 (COM)
CHANNEL 1 (NO)
Lift Master SL580 Gate Opener
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
CHANNEL 1 (COM)
CHANNEL 1 (NO)
CHANNEL 1 (NO)
CHANNEL 2 (NO)
CHANNEL 1 (COM)
CHANNEL 2 (COM)
RED WIRE to POSITIVE POWER
BLACK WIRE to NEGATIVE POWER
BATTERY or
TRANSFORMER
AC@53>@=B31B=@
(RB570 or R4222)
Channel 1 (GREEN WIRE to COM)
Channel 1 (BLUE WIRE to RELAY)
BLACK
RED
Channel 2 (BROWN WIRE to COM)
Channel 2 (YELLOW WIRE to RELAY)
GRN BLK RED
RECEIVER
COM COM
CYCLE
CLOSE
SAFETY
EXIT
OPEN
SHADOW
LOOP
CLOSE
EDGE
OPEN
EDGE
J11 J8 J12
8 to 24 VOLT AC/DC
POWER SUPPLY or BATTERY
RED WIRE to POSITIVE
BLACK WIRE to NEGATIVE
BATTERY or
TRANSFORMER
AC@53>@=B31B=@
(RB570 or R4222)