GUARDIAN GEAR ZW8198 User manual

Parts Identification:
A
B
D
1. Insert Vertical Upright Tubes (B) through the upright
support brackets on two of the Telescoping Horizontal Tubes (A).
2. Slide the Upright Extension Tubes (C) onto the two tops of the Vertical
Upright Tubes (B).
3. Attach the remaining Telescoping Horizontal Tube (A) to the ends
of the Vertical Upright Tubes (B).
4. Attach the two Wing Nuts (D) to the two Threaded Rods (E) as shown.
Press the Foot Support Inserts (F) into the Threaded Rods (E).
(Note: Inserts may already be connected to the rods.)
5. At an angle, press the Threaded Rods with attached Foot Support Inserts
into two of the Support Feet (G).
A
B
E
F
G
C
E
F
G
C
H
D
A. Telescoping Horizontal Tubes with
Upright Support Brackets (3)
B. Vertical Upright Tubes (2)
C. Upright Extension Tubes (2)
D. Wing Nuts (2)
E. Threaded Rods (2)
F. Foot Support Inserts (4)
G. Support Feet (4)
H. Screws (6)
ZW8198 Vehicle Barrier Assembly Instructions

A
H
Step 7
G
Step 6
A
D
Step 9
Step 8
6. Take the Threaded Rod/Support Foot assemblies from Steps 4 & 5 and
connect them to the Vertical Upright Tubes (B).
7. Insert the remaining two support feet (G) onto the tops of the
Upright Extension Tubes (C). (Note: Unless they are already installed,
do not use the extra foot support inserts for this step.)
10. When the Barrier is adjusted to your satisfaction, lock your
adjustments in place by installing the six Screws (H).
Thread the screws through the thin wall portion (the larger hole)
of the plastic vertical upright support brackets (A).
8. Place the Barrier in your vehicle with Threaded Rod Assembly
portion against the floor, and extend the barrier vertically
until it fits snugly against the floor and roof of the vehicle.
Use the Wing Nuts (D) to make adjustments.
9. Once the Barrier is firmly installed from top to bottom,
adjust the widths of the Telescoping Horizontal Tubes (A)
for a secure fit.