Idemia MorphoAccess VP MD User manual

COPYRIGHT© 2018 IDEMIA
Osny, France
MorphoAccess® VP MD –Installation Guide December 2018
2019_200000XXXX-V0
MorphoAccess® VP MD
Installation Guide

MorphoAccess® VP MD –Installation Guide
Warning
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
2
December 2018
Warning
COPYRIGHT© 2018 IDEMIA. All rights reserved.
Information in this document is subject to change without notice and do not represent
a commitment on the part of IDEMIA.
This document contains information of a proprietary nature to IDEMIA and is submitted
in confidence for a specific purpose. The recipient assumes custody and control and
agrees that this document will not be copied or reproduced in whole or in part, nor its
contents revealed in any manner or to any person except to meet the purpose for
which it was delivered.
This caveat is applicable to all the pages of this document.
This manual makes reference to names and products that are trademarks of their
respective owners.

MorphoAccess® VP MD –Installation Guide
Revision History
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
3
December 2018
Revision History
The table below contains the history of changes made to the present document.
Version
Date
Reference
Description
01
April 2019
2019_000000XXXX-V0
Document creation

MorphoAccess® VP MD –Installation Guide
Table of Content
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
4
December 2018
Table of Content
Warning ........................................................................................................................................ 2
Revision History ............................................................................................................................ 3
Section 1 : Introduction ................................................................................................................ 9
MorphoAccess® VP MD terminals........................................................................................... 10
Scope of the document............................................................................................................ 11
Safety Instructions................................................................................................................... 12
Wiring Recommendations ................................................................................................... 13
Regulatory, safety and Environmental notices ....................................................................... 14
European Union (CE) regulatory notices ............................................................................. 14
USA (FCC) regulatory notices............................................................................................... 15
Canada (IC) regulatory notices............................................................................................ 16
Others recommendations.................................................................................................... 17
Recommendations for terminal implementation.................................................................... 18
Section 2 : General Description .................................................................................................. 21
Box opening............................................................................................................................. 22
Components of the initial package ......................................................................................... 23
Terminal's front view description............................................................................................ 24
Terminal's rear view description ............................................................................................. 25
MorphoAccess® VP MD Technical Characteristics.................................................................. 26
Section 3 : Installation Procedure............................................................................................... 28
Before proceeding to the installation ..................................................................................... 29
Installation .............................................................................................................................. 30
Required tools (not supplied)............................................................................................... 30
Equipment from the initial package to use ......................................................................... 30
Step by step procedure ........................................................................................................ 31
Section 4 : Electrical Interface .................................................................................................... 35
Wiring overview ...................................................................................................................... 36
Power Supply........................................................................................................................... 37
External Power supply ......................................................................................................... 37
POE (Power Over Ethernet) ................................................................................................. 37
Output Relay ........................................................................................................................... 38
Nominal characteristics of relay.......................................................................................... 38
Example of connection for electrical door locks.................................................................. 38
Tamper Switch......................................................................................................................... 39

MorphoAccess® VP MD –Installation Guide
Table of Content
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
5
December 2018
Operating principle for the switch....................................................................................... 39
Nominal characteristics of switch block .............................................................................. 39
Wiegand port wiring ............................................................................................................... 40
Wiegand input wiring .......................................................................................................... 40
Wiegand output wiring ....................................................................................................... 41
The controller supports neither LED1 nor LED2 signals....................................................... 42
The controller supports only LED1 signal ............................................................................ 42
The controller supports LED1 and LED2 signals .................................................................. 42
Data Clock Input .................................................................................................................. 43
Data Clock Output ............................................................................................................... 43
RS-485 port wiring................................................................................................................... 44
GPIO wiring ............................................................................................................................. 45
Single Door Access Control (SDAC) implementation ............................................................... 46
Ethernet connection................................................................................................................ 47
Default Ethernet configuration ........................................................................................... 47
Recommendations for RJ45 wiring...................................................................................... 48
External USB connection ......................................................................................................... 49
Wi-Fi™ dongle installation ...................................................................................................... 50
Section 5 : User Interface ........................................................................................................... 51
Modes for controlling access rights ........................................................................................ 52
Introduction ......................................................................................................................... 52
Identification mode ............................................................................................................. 52
Authentication (verification) mode ..................................................................................... 52
Multi-factor mode ............................................................................................................... 53
Proxy mode.......................................................................................................................... 53
External database mode (also called polling mode) ........................................................... 53
Configuring the terminal......................................................................................................... 55
These Anti-tamper / anti-pulling switches.............................................................................. 56
Section 6 : Accessories, Software Licenses and PC Applications................................................ 57
Compatible Accessories, Licenses and Software..................................................................... 58
Compatible PC applications .................................................................................................... 59
Section 7 : Recommendations .................................................................................................... 60
Global warning .................................................................................................................... 61
General precautions ............................................................................................................ 61
Areas containing combustibles............................................................................................ 61
Specific precautions for terminals equipped with a contactless smartcard reader ............ 61

MorphoAccess® VP MD –Installation Guide
Table of Content
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
6
December 2018
Ethernet connection ............................................................................................................ 61
Date / Time synchronization ............................................................................................... 61
Cleaning precautions ........................................................................................................... 62
Main principles........................................................................................................................ 64
Most useful areas for biometric data...................................................................................... 65
Position of finger ..................................................................................................................... 66
Correct position ................................................................................................................... 66
Bad finger position .............................................................................................................. 67
Troubleshooting ...................................................................................................................... 68
How to get the latest versions of documents ......................................................................... 70
Documents concerning the MorphoAccess® terminal ............................................................ 71
Troubleshooting ...................................................................................................................... 73
The terminal IP address is unknown or it is not possible to connect to the terminal.......... 73
The sensor is switched off.................................................................................................... 73
The terminal returns erratic responses to Ping commands ................................................ 73
Technical Support and Hotline ................................................................................................ 74
North America ..................................................................................................................... 74
South America ..................................................................................................................... 74
South Africa ......................................................................................................................... 74
India:.................................................................................................................................... 74
Europe and rest of the world:.............................................................................................. 74
Web site............................................................................................................................... 74

MorphoAccess® VP MD –Installation Guide
Table of Content
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
7
December 2018
Annex 1 : Finger Placement Recommendations...................................................................... 63
Annex 2 : Bibliography ............................................................................................................. 69
Annex 3 : Support .................................................................................................................... 72

MorphoAccess® VP MD –Installation Guide
Table of Figures
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
8
December 2018
Table of Figures
Figure 1: Implementation Recommandations.............................................................................19
Figure 2: Box Opening..................................................................................................................22
Figure 3: Box Content ..................................................................................................................23
Figure 4: MorphoAccess® VP MD terminal front view ................................................................24
Figure 5: MorphoAccess® VP MD terminal rear view .................................................................25
Figure 6: Removing the top cover ...............................................................................................29
Figure 7: Drilling template ...........................................................................................................32
Figure 8: Wall plate fixing ............................................................................................................33
Figure 9: Terminal’s Body fixation ...............................................................................................33
Figure 10: Assembling top and bottom covers............................................................................34
Figure 11: Cabling layout .............................................................................................................36
Figure 12: Power supply wiring ...................................................................................................37
Figure 13: Output relay wiring.....................................................................................................38
Figure 14: Example of electric door strike connection................................................................38
Figure 15: Tamper switch wiring .................................................................................................39
Figure 16: Wiegand input wiring .................................................................................................40
Figure 17: Wiegand output wiring...............................................................................................41
Figure 18: Wiegand port wiring –DataClock...............................................................................43
Figure 19: Wiegand port wiring –Data Clock..............................................................................43
Figure 20: RS-485 port wiring –RS485 ........................................................................................44
Figure 21: GPIO wiring .................................................................................................................45
Figure 22: SDAC wiring.................................................................................................................46
Figure 23: Direct Point to Point Ethernet Connection.................................................................48
Figure 24: RJ45 wiring..................................................................................................................48
Figure 25: External USB connection ............................................................................................49
Figure 26: Wi-Fi™ dongle installation ..........................................................................................50
Figure 27: Most useful areas for biometric data.........................................................................65
Figure 28: Recommended finger positions..................................................................................66
Figure 29: Incorrect finger positions ...........................................................................................67

MorphoAccess® VP MD –Installation Guide
Section 1 :Introduction
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
9
December 2018
Section 1 : Introduction

MorphoAccess® VP MD –Installation Guide
Section 1 :Introduction
2019_200000XXXX-V0
IDEMIA DOCUMENT -REPRODUCTION AND DISCLOSURE PROHIBITED
10
December 2018
MorphoAccess® VP MD terminals
Congratulations for selecting the MorphoAccess® VP MD, first ever Physical Access
Control terminals to integrate the state of the art multimodal technology combining
finger vein and fingerprint biometrics.
This terminal brings to access control systems the strong assets of the finger
vein/fingerprint multimodality:
the capability to address those individuals who usually experience difficulties to use
mono-modal biometric devices,
an excellent FRR@FAR ratio, which allows a high security level without affecting
comfort of use,
an enhanced resistance to spoofing (by combining the protection mechanisms
intrinsic to each technology and also by making the most of the new characteristics
resulting from the fusion of the two biometrics),
while offering the same easiness of use which makes finger biometrics-based systems
quickly adopted by end-users.
In addition, the MorphoAccess® VP MD offers the following advantages:
high quality optical sensor (IQS quality sensor),
supports multiple input/output interfaces used in the physical access control
industry,
Local Area Network interface for easy interaction with other host systems ; LAN and
WLAN possibilities (Wi-Fi™ as an option),
practicality at installation and connection, as illustrated by this installation guide.
We definitely believe that our MorphoAccess® VP MD will come up to the expectations
of our faithful and most demanding partners, as the ultimate solution for Security,
Accuracy and Performance of their equipments!
To ensure the most effective use of your MorphoAccess® VP MD terminal, we
recommend that you read this Installation Guide completely and attentively.