Gumdrop BumpTech User manual

INSTALLATION
2
Press the other side of the keyboard down
to snap into the right side clip securely.
3
Slide the keyboard forward until it is flush
with the front edge of the case.
4
Close the device screen and carefully press the
rear corner clips to snap onto the keyboard.
5
Align the top edge of the device with the case’s
upper side clips. Slide the top case down until the
device is flush with the top edge.
1
Slide the device keyboard under the bottom case’s
le side clip.
6
Press the lower side clips over the device,
with pressure from both sides, to snap
into place securely.
GumdropCases.com
7
Close the case and press on the rear clips along the back
edge of the top case. Make sure all clips are securely
attached. *Case may have a 3rd clip at the center
Congratulations on your new case! BumpTech

REMOVAL
CRITICAL!
FOLLOW STEPS 1 - 3 IN ORDER
Failure to do so may result in
damage to the device.
1
Unhook the rear clips along the back edge of the
top case. *Case may have 3rd clip at the center
2
Push the lower le and right side clips
outward to release the bottom of the top
case from the device.
4
Gently push the rear clips down to unhook from
the device. *Closing device partially may help
with this step
5
Push the le and right side clips down past
the device, one side at a time, to release the
bottom case.
3
Gently slide the top case up and off the device to
release it from the upper side clips.
GumdropCases.com BumpTech
The PC case is recyclable if the feet and EDP
(Energy Displacement Protection) are removed!