GVA GVAD200B User manual

Instruction Manual
DVD Player
/ GVAD200B

The apparatus shall not be exposed to dripping or splashing and no objects filled with
liquids, such as vases, should be placed on the apparatus.
The mains plug is used as the disconnect device and it should remain readily operable during
intended use. In order to disconnect the apparatus from the mains completely, the mains plug
should be disconnected from the mains socket outlet completely.
Batteries must not be exposed to excessive heat such as sunshine, fire or the like.
Caution markings are located at the rear or bottom of the apparatus.
The marking information is located at the rear or bottom of apparatus.
IMPORTANT SAFETY INSTRUCTIONS
•
•
•
•
•
•
•
Additional Warnings
WARNINGS AND PRECAUTIONS
•
• WARNING: Do not place the unit on top of any soft, porous, or sensitive surfaces to avoid
damaging the surface. Use a protective barrier between the unit and surface to protect the surface.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This symbol indicates that this product
incorporates double insulation between hazardous
mains voltage and user accessible parts.
Read these Instructions.
Keep these Instructions.
Heed all Warnings
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Do not block any ventilation openings. Install in
accordance with manufacturer instructions.
Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
Only use attachments/accessories specified by the
manufacturer.
11. Refer all servicing to qualified
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such
as power-supply cord or plug is
damaged, liquid has been spilled
or objects have fallen into the
apparatus,the apparatus has
been exposed to rain or moisture,
does not operate normally, or has
been dropped.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Young children must be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced before further use by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.

Remote Control
Plug the attached AC cord into a standard AC
power outlet to power the DVD player.
Introduction and Setup
Power
Requires 2 AAA batteries (not included).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries
Remote
N126
220-240V~ 50/60Hz
POWER CONSUMPTION :15W
Product description: 2CH DVD PLAYER
WARNING:To prevent fire or electric shock do not expose this
apparatus to rain or moisture.Disconnect the main plug from supply
socket when not in use.Please do not place a water filled object on
top of your DVD player.
WARNING:Dangerous high voltages inside.To prevent the risk
of electric shock do not remove the cover.No user serviceable
parts inside.Refer all service queries to qualified personnel.
GVAD200B
SR NO.:
L,R OUTPUT CVBS OUTPUT
220V-240V~
50/60Hz 15W
N126
220-240V~50/60Hz
POWER CONSUMPTION:15W
Product description: 2CHDVDPLAYER
WARNING:To preventfire or electricshock donot expose this
apparatus to rain or moisture.Disconnect the main plugfrom supply
socketwhen not in use.Please donot place a water filled objecton
top of yourDVDplayer.
WARNING:Dangeroushigh voltages inside.To preventtherisk
of electric shockdo not removethe cover.Nouser serviceable
partsinside.Refer all servicequeries to qualified personnel.
GVAD200B
SRNO.:
220V-240V~
50/60Hz 15W
Stop
Press to stop a loaded
disc during play
Power
Press to turn the DVD
player off or on.
Play/Pause
Press to play or pause
the loaded disc.
Open/Close
Press to open or close
the
Disc Drawer
Disc
Drawer
USB
USB Port
Receiver of
Remote Control
LED light
USB Function
OPEN/CLOSE MUTE
GOTO
AUDIOANGLESUBTITLETITLE
VOL +
ENTER
SETUPMENU
A-BSTEPRANDOMPROG
REPEATSLOWN/PL/R
ZOOMUSB/DVD
USB/DVD
OSDSTOP
Number Keypad
Subtitle
Title
Menu
Press to access
the main
menu on a
loaded DVD.
Setup
Press to access
the setup menu.
Skip
Search
OSD
Stop
N/P
Press to switch
between NTSC
and PAL.
L/R
Prog
Open/Close
Mute
Power
Goto
Angle
Audio
Arrows/Enter
Play/Pause
Volume
Zoom
Slow
Repeat
A-B
Step
Random
Y Pb Pr (COMPONENT) OUTPUTS
(Progressive Scan)
Supported file formats for playback from connected USB
device (not included): mpg, mp4, mp3, wma, dat, jpeg
Maximum capacity: 32GB

1. Press the Open/Close button to open the
Disc Drawer .
2. Load a disc into the DVD player, label side
facing up.
3. Press the Open/Close button to close the
Disc Drawer .
4. After a disc is loaded, it will begin playing
automatically.
1. Follow the instructions for Loading a Disc
and Playing a Loaded Disc.
2. While the loaded disc is playing, press the
PROG button on the remote.
3. Use the Arrows/Enter/Number Keypad
buttons to highlight and select a DVD title
and chapter, or CD track.
4. Highlight the PLAY button to play.
5. DVD Titles and chapters or CD tracks will
play in the order they are programmed.
6. Repeat step 3 until the desired DVD
titles and chapters or CD tracks are
programmed.
DVD and CD
Loading a Disc
1. Follow the instructions for Loading a Disc.
2. If the disc does not begin playing
automatically, press the Play/Pause
button.
Playing a Loaded Disc
Programming a Loaded Disc
1.
2.
3.
4.
Load a JPEG photo disc into the player
by following the instructions for Loading
a Disc.
A slide show of JPEG photos from the CD
will begin playing automatically.
Press the Stop
view of the loaded JPEG disc.
Use the Arrows/Enter buttons on the
remote to select and view photos.
Playing a JPEG CD
Press the Stop button on the remote twice.
In order to access all of the features of the DVD
setup menu, the DVD player needs to be fully
stopped.
Access the DVD Setup Menu
Connecting Video and Audio
Note: Before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.
1. Use the RCA Stereo Audio Output
to
send audio from the DVD player to a
television.
2. Requires an RCA audio cable (included).
3. Use the RCA audio cable to connect the
RCA Stereo Audio Output to an RCA
stereo audio input on a television.
4. Adjust the connected televisions input
setting to match the input used in the
previous step.
RCA Stereo Audio Output
Press the Setup button on the remote.
220V~240V-50/60Hz
GVAD200B
15W
225x38x210mm
2
220V~240V-50/60Hz
15W
N126
220-240V~ 50/60Hz
POWER CONSUMPTION :15W
Product description:225mm 2CH DVD PLAYER
WARNING:Toprevent fire or electric shock do not expose this
apparatus to rain or moisture.Disconnect the main plug from supply
socket when not in use.Please do not place a water filled object on
top of your DVD player.
WARING:Dangeroushigh voltages inside.To prevent the risk
of electric shock do not remove the cover.No user
serviceable parts inside.Refer all service queries to
qualified personnel.
SR.NO.:
GVAD200B
2.0CH INPUT
TV
DVD Player
(Rear View)
Amplifier
The video cable connection can be made using
either the CVBS output (good) or the Y,Pb,Pr
outputs (better), depending on the available
inputs on your TV.
The audio cable connection must be made from
the DVD player's L/R audio outputs to the
corresponding inputs on your TV (or amplifier).
See below for connection details:

WARRANTY INFORMATION
Please note:
STATUTORY WARRANTY INFORMATION
owner's