GXH BARN DOOR TABLE User manual

User Manual v1.0
LAND CRUISER BARN DOOR
TABLE - COMPLETE KIT

2 3
Product Overview
Designed specically for the Land-Cruiser 76 series / Troopy barn door,
this fold down table adds valuable and easy to access work space to
your vehicle for those road side pit stops or camping trips.
Our unique table design also provides multi-purpose functionality and
can be used with a at or lipped work surface to prevent items from roll-
ing off. It can also be stowed such that at items (e.g. a utensil pouch or
chopping board) can be stored inside the table out of sight.
This kit comes with all the fasteners required for installation on your
Land-Cruiser 70 series or Troop carrier. An M5 nustert tool is required for
installation and 4 clearance holes will also need to be drilled into your
door for tment.
76 Series Land-Cruiser
78 Series Land-Cruiser*
*Note: This table cannot be used with the later model Troop carriers stock
speaker arrangement which has a speaker on the barn door. Re-locating
of the speaker is required.
Introduction
Whats In The Box
Product Dimensions
x 1x 1
x 18x 10 x 18
Compatibility

4 5
The rst step in the installation process is to remove the stock door card.
This is easily achieved by getting under the corner of the door card and
gently pulling out to release the plastic retaining clips which hold it in
place. Once the rst clip is out, work your way around the panel until all
10 clips are released and the door card is free.
Using an M5 nutsert tool, install the provided nutserts* into the 10 holes
where the plastic clips previously retained the door card. Depending on
the stroke length, some nutsert tools may require that you re-thread the
nutsert and compress it into the door multiple times for proper tment.
Important: Before proceeding please make
sure that the nutserts have been properly
compressed and are seated securely into the
holes.
*Please refer to your respective tools operat-
ing manual for instructions on how to install.
STEP 1: Removing the Rear door card
STEP 2: Inserting the nutserts
Now that the nutserts have been installed. Align the mounting panel
against the door locating it with two of the provided screws. You will see
that there are 4 positions where the inner pre-tted nutserts in the panel
interfere with the vehicles door. These are the positions where you will
need to drill clearance holes.
Using a thin marker, spot through and mark where these holes need to be
drilled. Next, remove the panel and carefully drill holes in the marked po-
sitions. We recommend pulling up the plastic sheeting behind the door
prior to drilling to avoid metal swarf being caught on the inside.
We suggest using a step drill for this
step, you can start with a smaller hole
and work your way up in size until you
have the appropriate clearance. The
holes should be approximately 9 mm.
Installation STEP 3: Drilling the clearance holes
NUTSERTS GO HERE
DRILL HOLES HERE

6 7
Using the provided M5 x 16 screws and shake proof washers, fasten the
mounting panel onto your vehicle making sure every screw is in position
before going around and rmly tightening everything down.
Using the provided M5 x 16 screws and shake proof washers, fasten the
table to the mounting panel. The table will need to be in its open position
in order to access all the holes. We recommend getting someone to help
hold the table in position for this step.
Finally, go back and make sure that all the screws are secure. Now is also
a good time to check the operation of the table and make sure that ev-
erything is correct.
For any assistance please contact [email protected]
STEP 4: Fasten the mounting panel STEP 5: Fasten the table onto the panel
STEP 6: Final Inspection

8