GZAIR SA1600PRO User manual
USER’S MANUAL (VALVE)
CO2 MONITOR & CONTROLLER
WITH REMOTE SENSOR
MAIN FEATURES
OVERVIEW
•
•
•
•
•
•
•
•
•
•
1
This is a plug and play product.
PACKING LIST
CO2 Controller Unit
Instruction Manual
X3
Installation Screws
Sensor Kit
2
▪Keep the controller unit and sensor kit away from
water mist, in case it effects the accuracy and
lifetime of the product.
▪Use the provided screws to install the controller unit
and remote sensor kit on the wall, make sure them
firmly installed.
▪Before power on, make sure the controller and
sensor kit are firmly installed on the wall.
▪If it displays , it means that the remote sensor kit is
not connected properly.
POWER SUPPLY
!
CAUTION
CO2
3
Controller Panel
Power supply indicator
Solenoid valve indicator
Fan indicator
light-sensitive indicator
Increase the value in
selection mode or settings
Decrease the value in
selection mode or settings
Enter settings
Save and complete the
settings
4
LCD DISPLAY
Time menu. Setting date and time.
Valve control status
Photosensitive mode on
Photosensitive mode off
Setup menu
Setting CO2 center value, CO2 zone value, working
time and interval time.
Calibration menu.
5
Notice:
If not connected properly,
the controller panel will
display ‘E1’.
OPERATING INSTRUCTIONS
Installation
Connection for sensor
and controller
①
②
③
④
③④
Port 1
Port 2
①
②
6
!
POWER ON
READY TO USE
Ambient CO2 Readings,
Set Center value and Set
Zone value will constantly
displayed on the screen.
7
BACKLIT DISPLAY
PHOTOCELL SENSOR
CO2 OUTPUT CONTROL
8
SETTINGS
MAIN MENU FUNCTIONS
MENU FUNCTION SETTINGS
9
CO2 CENTER VALUE, ZONE VALUE, WORKING
TIME, AND INTERVAL TIME SETTINGS
Demonstration
Tip:
Restore Factory Setting
will reset the device to
factory settings. To use
Restore mode, hold
for 3 seconds until an
audible beep is heard.
10
To set and save as 24-hour
system, press while
AM and PM flashes
simultaneously.
DATE & TIME SETTING
Demonstration
11
▪
▪
▪
400ppm.
!Notice
In normal state, hold for 3 seconds until a beep to
reset the device to factory settings. Once selected, the Set
Center value is 1200ppm, Set Zone value is 200ppm, Set
working time is 0 second and Set interval time is 0 second.
RESTORE FACTORY SETTING
Re-calibration (Use with caution)
12
SPECIFICATIONS
13
SA1600PRO
0~3000ppm ±50ppm +5%reading
5A AC
APPENDIX
DISCLAIMERS
14
Table of contents
Other GZAIR Controllers manuals
