Häfele FITT-10080 User manual

Tools required (Not Supplied)
Component parts
Assembly guide
• Make sure all the components are included before
you start.
• The number for technical support is at the bottom
of the page.
• Dont rush!
• Read the instructions first.
• Assemble in the stages shown.
• Keep the fittings together to avoid loss.
• Have fun.
Pencil
Bradawl
Spirit Level
Cross Head Screwdriver
Tape measure
Did you know Häfele also supply tools to the trade and industry?
See www.hafele.co.uk for more information.
Pull-out wine rack:
1 x Frame (A)
2 x Runners (B)
PLEASE NOTE: For minimum installation cabinet width 450 mm and depth 495 mm
4 x wine bottle shelves (C) for item 541.94.211 & 541.94.223
6 x wine bottle shelves (C) for item 541.94.213
1 x wine glass shelf (D) for item 541.94.223
3 x M6
Hexagon nuts (G)
16 x M4 x 30 mm
Pan head screw (H)
4 x M6
locking washer (F)
1 x Handle (E)
Using the runner drilling pattern (shown left), fix
the spacers (I) and the runners (B) to the inside
face of the cabinet, using 16 x M4 x 30 mm pan
head screws (H) at floor level of cabinet.
1
580
495
Minimum Dimensions
450
Front edge of carcase
(Hole centre distance)
(Hole centre distance)
178
82 74 74
178
82 74 74
58
58
(For item 541.94.211)
(For item 541.94.213 & 541.94.223)
Overall frame height 480/625
604
459
4 x Spacers (I)
FITT-10080
Issue - 01
Sales and Technical Support -
Tel: [phone], Fax: [phone], E-Mail: [email protected]

Steps 2 to 4
Assembly guide Pull-out wine rack:
Place the wine glass shelf (D) to the frame (A) after assembling
4 x wine bottle shelves.
(This is only applicable for item 541.94.223)
4b
3
Attach the frame (A) to the runners (B) with the 2 threaded bolts
on each of the runners going through the matching holes on
the horizontal edge of the frame. Secure with 4 x locking washers
(F) with 3 x hexagonal nuts (G) and 1 x pull handle (E) to the top
front, as shown above.
Assemble wine bottle shelves (C) to the frame (A). To do so tilt 90º so
that the front side of wine shelf faces upwards towards top of cabinet.
Insert both ends on to the corresponding holes; lower end so holder
sits parellel to the base of the cabinet. Work from the bottom up.
2
Finished wine pull-out unit.
4 x wine bottle shelves for item 541.94.211
6 x wine bottle shelves for item 541.94.213
4a
Sales and Technical Support -
Tel: [phone], Fax: [phone], E-Mail: [email protected]