H2 Wellness Hydrogen Water Bottle User manual

Hydrogen Water Bottle
www.acepax.ca
[email protected]
Instagram: h2wellness | acepax.ca
Plastic Bottle Glass Bottle

The most innovative technology:
* Proton Exchange Membrane (PEM) technology from Japan
*State of the art Solid Polymer Electrolysis (SPE) technology
* Works with all types of drinking water including Distilled and RO
* Separates and expels harmful by-products of Chlorine, Ozone and Oxides
* Produces the highest industry levels of molecular Hydrogen concentrates
* Uses safest high-quality Korean Platinum coated Titanium Electrode Plates
* Best portable generators in the industry
*No filters or any expensive parts to replace
Product Diagram:

Quick Start Guide
Set Up:
•Wash glass/plastic bottle and lid with warm water. Remove bottle from generator
firstly then wash the bottle glass/plastic container.
•Twist plastic plug off on the electrode plate.
•Twist glass/plastic bottle on to generator.
•Cap bottle with lid and insert USB cable into USB Port.
Insert other cable end to power plug and plug it into outlet.
•Charge Unit for 2-3 hours until green light turn on then take off charger.
•With bottle attached rinse out Generator with warm water.
•Fill bottle up to 90% of the bottle with clean drinking water.
•Operate generator to make hydrogen-rich water.
To Operate:
1. Press power button. The working indicator light will turn blue, making hydrogen-rich water
for 3 minutes. Press the button for twice quickly in a row will turn the working mode to be 10
minutes. Pressing button when unit is working will turn power off.
2.After a 3 or 10 minutes cycle the working indicator blue light will turn off, completing
process. For higher concentration of H2, use the 10 minutes cycle.
3. You can drink the hydrogen-rich water directly out of the bottle or pour it into another
container. It is best to drink water within one hour. Hydrogen will dissipate over time.
4. Self-cleaning: Press and Hold the switch button for three seconds, the working indicator
light turn green, the positive and negative electrodes will be swapped and the machine will enter
the automatic self-cleaning mode.
5. Charging: If the working indicator light flashes blue, this means the battery power is low and needs
to be charged. Plug the USB power adapter (Mobile phone charges) into the wall and plug the USB
power cable into the adapter, the indicator light on the power button turn red when it is charging. The
charging micro USB charging port is located underneath the rubber cover on the generator base. When
charging is complete, make certain the rubber cover is inserted into the micro USB port. This will
keep water from entering the base and electronics. When charging is complete, the red indicator light
will turn green.
The battery has an expected life of 500 charges. Keeping your machine plugged in all day
during use may prematurely cause your battery to fail sooner. It is ok to finish cycling to
operate while charging if your battery dies during operation, but do not use again until
battery fully charges and light stops blinking. Do Not Keep Plugged In.

6. Inhaler usage: Remove the rubber protector from the port(Install the rubber protector onto its
origin port after inhalation),then open the rubber cover on the cap, attach the Cannula breathing
tube to the Cap-Lid by slipping the Cannula tubing end with the open end onto the snorkel valve
protruding in the center of cap. Fill machine bottle ¾ of the way full of water and screw on cap
to the top of the bottle with the Cannula breathing tube attached.
Place the loop end of the Cannula tube over your head and the two breathing prongs into each
nostril and adjust the slack-bead behind neck to be snug against the back of your head.
Daily Use:
•Never leave plugged in while using during the day. Always discharge the
battery some or all before recharging.
•For maximum benefit drink 4 – 5 bottles or more per day.
•Use any clean purified water when possible to keep plates clean.
•Never let the Generator dry out and leave a little water to keep the electrode
plate moist.
•Do self-cleaning one time every week. Self-cleaning water can not drink,
just pour away.
Advisories:
•Never operate Generator without water in the bottle.
•Keep USB Port sealed by plugging its cover back in.
•Operate only with any type of clean drinking water.
•Not for use with hot, carbonated or other beverages.
•Always keep Generator Plate Well wet and never store dry.
•Unit will stop charging when LED lights turn green.
•Do not place Generator unit in a refrigerator or cooler.
•Do not soak or submerge Generator Unit under water.
•Operate only for the water you will drink in one hour.
•Avoid direct sunlight or heat that can dry out the plates.
•Use room temperature water. Never freeze or use ice.
•Never use any chemical cleaners on Generator unit.
•Keep away from children, Pets, Heat and Flames.
•Do not pull cable from wire or plug with wet hands.

Occasional Descaling Maintenance:
Depending on the mineral oxide content in your drinking water, clean the
electrolysis plates by descaling once a month if necessary. To descale simply add 1
part either white vinegar, lemon juice or citric acid to 3 parts water into the bottle
and leave generator soaking in mix overnight.
Dump and rinse thoroughly with warm water before using again.
Disclaimer: These Products have not been evaluated and are not
intended to diagnose, cure, treat or prevent disease. Seek medical
advice if seriously ill and or attempting to cure or prevent disease.
Trouble Shooting
No visible bubbles
•Check power source
No light when
operating unit
•Low battery indicator
•Charge Unit ASAP
Low PPM levels
when tested with
Blue Drops
•Operate the unit more times to activate
PEM membrane
Wetness in Generator
• Units are shipped wet
Battery not charging
•Check for defective Plug or cable
Machine is
Leaking water
•Check all seals, tighten lid
•Fill water up to 90 % of the Bottle
Bottle has odor or
Unit makes less gas
• Clean descale as needed
•Use different water source
Unit stopped working
•Contact For Support
Glass bottle broke
•Contact to order replacement
Unit stopped charging
•Contact For Support
For All Other Issues or Unsolved Problems Contact For Support
Warranty: One Year due to defective Parts or Labor

Product Specifications
Power
USB 3.7V / 2A Output: ≤5W Micro USB
Bottle Max Capacity
400ML
Water Type Required
All Drinking Water Types
Water Temperature Range
32ᵒ–140ᵒF / 0ᵒ- 60ᵒC
Dimensions
70mm W x 230mm Ht
Unit Net Weight
300G(Tritan) / 450G(Glass)
Electrode Plates
Korean Titanium Platinum
Membrane
Japanese Ion Membrane
Hydrogen Generation Range
Depends on working time /1000 –2000 ppb
ORP Range
Minus 350mv ~ Minus 750mv
Bottle Material
Borosilicate Glass or Tritan
Quick Guide:
Press Power Button 1 time = 3 Minutes Cycle (Blue LED Light), light off means completed
Press Power Button 2 times = 10 Minutes Cycle (Blue LED Light), light off means completed
Press & Hold Power Button = Self Cleaning (Green LED Light), light off means completed
To Cancel: Press Power Button again.
***
Blinking Blue LED Light = Please charge the Bottle.
Green LED Light On = Charging is Completed.
***
Hydrogen Inhaler Directions
Please consult your doctor before using Hydrogen Inhaler!
For first time user, start inhalation process for 10 minutes per day.
Slowly increase the time to 13 minutes per day in the week 2.
Increase the time to 20 minutes in the week 3, and so on.
Do Not Rush to achieve hydrogen.
Youth can increase the time quickly; the elderly should be as slow as possible.
WARNING!!! Stop Use and Ask a doctor if:
*Any discomfort feeling appears
*For Pacemaker Carrier, drinking hydrogen rich water is forbidden.
********