Haden HDC85L User manual

HDC85L
85L DRINKS CHILLER
INSTRUCTION MANUAL
PRODUCT CODE : 200037

01.
CONTENTS
SAFETY INFORMATION 2
INSTALLATION 5
PRODUCT OVERVIEW 6
SETTING THE TEMPERATURE 7
ENERGY SAVING TIPS 8
CLEANING AND MAINTENANCE 8
TROUBLESHOOTING 9
EARTHING 10
WEEE 10
WARRANTY 11
TECHNICAL SPECIFICATION 12

02.
SAFETY INFORMATION
Read these instructions carefully and completely before using your
appliance and keep in a safe convenient place for reference when
necessary.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
• The appliance is not to be used by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction. Children should be supervised and
ensure they do not play with the appliance
• If the product is handed over to someone else for personal use or
second-hand use purposes, the user manual, product labels and
other relevant documents and parts should be also given.
• Before installation, read the instructions carefully.
• Do not operate the product if it is defective or has any visible
damage.
 Children shall not play with the appliance
• Keep all packaging well away from children.
• Only connect the product to a grounded outlet/line with the
voltage and protection as specified in the “Technical
specifications”.
• Don’t store chemicals, aerosols or liquids such as ether,
methanol, petrol or chemicals that easily evaporate, burn or
explode.

03.
SAFETY INFORMATION
• Never wash the product by spreading or pouring water onto it!
There is the risk of electric shock!
• Never touch the plug with wet hands! Never unplug by pulling on
the cable, always pull out by holding the plug.
• The product must be disconnected during installation,
maintenance, cleaning and repairing procedures.
• Cleaning and user maintenance shall not be made by children
without supervision.
• If the power connection cable for the product is damaged, it must
be replaced by a qualified persons in order to avoid a hazard.
• The appliance must be installed so that it can be completely
disconnected from the mains supply.
• To aviod a hazard due to instability of the appliance, it must be
placed in accordance with the instructions.
• Do not locate multiple portable socket-outlets or portable
supplies at the rear if the appliance.
• Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear of obstruction.
• Do not use mechanical devices or other means to accelerate the
defrostiong process.
• Do not use electrical appliances within the drinks storage
compartments of the appliance.
• Do not damage the refrigerant circuit.
• Children aged from 3 to 8 years are allowed to load and unload
refrigerationg appliances.
• It is not recommended to use an extension lead to power this
appliance.

04.
SAFETY INFORMATION
• To aviod contamination of drink, please respect the following
instructions:
- Opening the door for long periods can cause a signifcant
increase of temperature in the compartment of the appliance
- Clean the sufaces regularly that can come in contant with drink
and accessible drainage systems.
- If the refrigertating appliance is left empty for long periods,
switch off, defrost, clean, dry and leave the door open to prevent
mould developing within the appliance.
• This appliance is intended to be used in household and similar
applications such as staff kitchen areas in shops, offices and
other working environments; farm houses and by clients in
hotels, motels and other residential type environments; bed and
breakfast type environments; catering and similar non-retail
applications.
Note: This appliance contains flammable refrigerant R600a and
cyclopentane foaming material.
Therefore, when the refrigerator is scrapped it shall be kept away from
any fire source and be recovered by a special recovering company with
corresponding qualification other than be disposed by combustion, so as
to prevent damage to the environment or any other harm.

05.
INSTALLATION
This appliance is designed to be free standing only. As such should not be
recesed or placed inside built-in cupboard covered with a door.
• For safe lifting, tilt the appliance backwards by no more than 45
degrees, hold the base and rear corners of cabinet. Lift the
appliance carefully.
• Never use the door handles for lifting.
• Do not apply force on any part such as condenser and door to
prevent the refrigerator from deforming, or else it will influence
its performance.
• Do not site in a location which is likely to drop below 16 degrees
centigrade, i.e. garage or shed in winter.
• Install the appliance on flat, firm ground to prevent vibration and
noise. Adjust the feet located at the front base of unit, to ensure
the item is level.
• Choose a dry and well-ventilated location. A space of no less than
7cm must be left around the chiller.
• Choose a location where there is no heat source. Keep the
appliance away from direct sunlight, radiators, heaters, ovens etc.
• Wipe all internal parts with warm water mixed with a gentle
cleaning solution and then rinse with clean water and then dry.
• Allow to stand for a minimum of 24 hours after moving and before
plugging in to mains.
• Once plugged in to the outlet allow 2-3 hours for the appliance to
cool to the required temperture before placing drinks inside.
THIS APPLIANCE MUST BE PLUGGED IN TO AN EARTHED SOCKET.
DO NOT USE AN EXTENSION REEL WITH THIS APPLIANCE.

06.
PRODUCT OVERVIEW

07.
SETTING THE TEMPERATURE
• Your appliance has only one control for regulating the temperature
in the compartment. The temperature control is located at the
upper right had side of the compartment.
• The first time you turn the unit on, set the temperature control to
‘5’
• The range of the temperature control is from postion ‘0’ to ‘5’.
After 24 to 48 hours, adjust the temperature control to the setting
that best suites your needs. The setting of ‘3’ or ‘4’ should be
appropriate for a home or office us.
• To turn the appliance off, turn the temperature control to ‘0’.
• WARNING: Accessible parts may become hot during use. Young
children should be kept away.
Note:
• Turning the temperture control to ‘0’ position stops the cooling
cycle but does not shut off the pwer to the unit.
• If the unit is unplugged, has lost power, or is turned off you must
wait 3 to 5 mintues before retarting the appliance. If you attempt
to restart before this time delay, the unit will not start.

08.
ENERGY SAVING TIPS
• The appliance should be loacted in the coolest area of the room,
away from heat producing appliances and out of the direct
sunlight.
• Wipe containers dry before placing thin in the unit. This cuts
down on frost build-up inside the unit.
CLEANING AND MAINTENANCE
Please turn off the power before cleaning interior, remove all foods,
drinks, shelves, drawers, etc.
• Wipe the inner and outer sides with a soft cloth or sponge using
warm, clean, soapy water. The interior of the refrigerator should
be cleaned regularly to avoid odour.
• Remove the parts individually and wipe with warm, clean, soapy
water. Do not wash in a dishwasher.
• Never use flammable, explosive or corrosive materials for
cleaning the appliance.
• Check the door gasket regularly to make sure there are no
debris. Clean the door gasket with a soft cloth dampened with
soapy water or diluted detergent.
• Wipe the outer surface of the refrigerator with a soft cloth
dampened with soapy water, detergent, etc., and then wipe dry.
• Don’t use hard brushes, clean steel balls, wire brushes,
abrasives, organic solvents, boiling water, acid or alkaline items,
which may damage the fridge surface and interior. Boiling water
and organic solvents such as benzene may deform or damage
plastic parts.
• Do not rinse directly with water or other liquids during cleaning
to avoid short circuits or affect electrical insulation after
immersion.

09.
TROUBLESHOOTING GUIDE
PROBLEM
Unit does not operate.
POSSIBLE CAUSE
Not plugged in.
The circult breaker tripped or a blown fuse
The unit temperature control is set ‘0’ position
Turns on and off frequently The room temperature s hotter than normal.
A large amount of food / drink has been added
to the unit.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The unit does not have the correct clearances.
Vibrations
The unit seems to make too much
noise.
Check to assure that the unit is level
The rattling noise may come from the flow of
the refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in
your unit.
Contraction and expansion of the inside walls
may cuase popping and crackling noises.
The unit is not level.
The door will not close proplerly The unit is not level.
The door was reversed and not properly
installed.
The gasket is dirty or bent.
The shelves are out for position.

10.
EARTHING
WASTE ELECTRICAL RECYCLING
This symbol indicates the product is classed as
Electrical or Electronic Equipment and should not be
disposed of with other household waste.
The Waste Electrical and Electronic (WEEE) Directive
has been
introduced across the EU:
• to recycle waste electrical products using the
best available recovery and recycling
techniques in order.
• to minimise the impact on the environment
• to treat any hazardous substances and
• to avoid increasing landfill.
WEEE product should be disposed of by handing it
over at a designated collection point. For more
information about where you can drop off your waste
product for recycling please contact your local
authority.
IMPORTANT – This is a Class I Electrical Product. It requires an
Earth connection.
WARNING! ELECTRIC SHOCK HAZARD.
DO NOT DISASSEMBLE THIS APPLIANCE. TOUCHING SOME OF THE
INTERNAL COMPONENTS CAN BE EXTREMELY HAZARDOUS.
This appliance must be earthed.
Consult a qualified electrician or service engineer if the earthing
instructions are not completely understood or doubts exist as to
whether the appliance is properly earthed.