Hagen Vivexotic viva tortoise table extension User manual

STARTER FITTINGS PACK

{

Only required if using

PT 2223

EXTENSION FITTINGS PACK

This product requires a tortoise table starter kit. If you have already built the

starter, please dismantle it and use the panels and fittings as shown below.

STARTER PANELS EXTENSION PANELS

Arrow on

cam facing

towards

edge

We recommend Exo Terra reptile

accessories for use with Vivexotic products.

Please refer to the ‘Exo Terra Essential

Care & Equipment Guide’ included with

the starter table for further details.

To raise this product off the ground,

you can purchase a stand.

2 stands are required for this set up

PROTECTING YOUR VIVARIUM - SILICON SEALING

Wooden vivariums are not recommended for pets that require tropical

environments. It is advised that once built, you seal all joints and exposed

fittings with aquarium silicon sealant, and leave overnight to cure. This

sealing will prolong the life of your vivarium and proactively safeguard

against accidental water spills and pet wastes. If your pet requires misting,

it is essential that no excess water is left pooling within the vivarium. If

water is allowed to seep into exposed joints, gaps or inadequately sealed

edges the wood will swell.

We strongly recommend that the vivarium is sealed fully after construction,

particularly where humidity levels are high. We recommend that humidity

levels do not exceed 65% in any wooden vivarium and cannot guarantee

the longevity of the vivarium in this case.

For species requiring high levels of humidity we recommend Exo Terra

Glass Terrariums. Please visit www.exo-terra.com for more details.

If you need help, or have damaged or missing parts, please call 0141 945 2888 and ask for the QC department. However, please note if your

product has been subject to obvious carrier damage to the carton during transit to your home, we recommend that you contact your supplier.

Important - Please read these instructions fully before starting assembly

MADE IN THE UK

Issue 1

ASSEMBLY INSTRUCTIONS

TORTOISE TABLE EXTENSION

PT 4030

ASSEMBLY

Make sure the 4 unused

12mm deep holes (for

optional legs to be

attached) on panels 1 & 9

are facing upwards

Slide the front glass panel

down through the grooves

(painted side should be to the

outside of the table)

2 YEAR EXTENDED WARRANTY

You have automatically received a standard 12 month guarantee with your purchase. However, you will receive an additional 12

months free (giving you a total of 2 years warranty from the date of purchase), if you complete the online product warranty

registration form. Simply visit

uk.hagen.com

and click on the ‘warranty’ section. Please keep your original receipt as proof of

purchase.

The standard and extended warranty covers for defective parts which have failed under normal use. We shall not replace parts that have been damaged by abnormal conditions or that

which have been subjected to improper use. It is important that you seal your vivarium to prevent moisture entering into exposed chipboard. We will not replace parts that have been