5. Screw the lock lever(A*14 pcs) into the top plate(⑨), then install in the
mounted section of step 4 with lock catch(B*14 pcs). Screw the shelf nail
(E*8 pcs) into the plate holes. (Note: the arrow direction of the lock catch(B)
need to align the lock lever(A), tighten in “+” direction and loosen in “-” direction)
Installation Instructions
1. Place the back board (①), left side board (②) and the right side board
(③) as below picture show, screw the locking lever (A*4 pcs) into the left
and right side board holes separately, then use the lock catch (B*4 pcs) to
lock them down. (Note: the arrow direction of the lock catch(B) need to align
the lock lever(A), tighten in “+” direction and loosen in “-” direction).
2.
Place the mounted section on the ground horizontally, screw the lock lever
(A*8 pcs) into the left side board(②), right side board(③), left-middle side
board(④) and right-middle side board(⑤) holes separately, then use the lock
catch (B*8 pcs) to lock the middle fixed panels(⑥). (Note: the arrow direction
of the lock catch(B) need to align the lock lever(A), tighten in “+” direction
and loosen in “-” direction)
3
. Screw the foot pads(D*10 pcs) onto the opposite side of the bottom board
(⑦) with screws(C*10 pcs); Screw the lock lever (A*14 pcs) into the obverse
side of bottom board(⑦), then use the lock catch(B*12 pcs) to lock them
down. It is recommended to turn the bottom side up when installing this step;
(Note: the arrow direction of the lock catch(B) need to align the lock lever(A),
tighten in “+” direction and loosen in “-” direction)
2
6
6
3
4
5
1
A
B
1
2
3
A
B
7
7
A
B
C
D
180
4. Install the middle-side board(⑧) and screw down with the lock catch
(B*2 pcs) according to the figure.
8
B
9
E
13
13
14
12
12
11
10
14
11 10
J
I
F
HFront hole
Back hole
Firstly, install the door hinge into
the hinge lead hole of side board,
then adjust the gap of door, finally
install and connect the side board
and the door plate with door hinge.
6.
Install and fix the door hinge(G* 4pcs) with screws (F*24pcs) on the plate
(⑩) and plate(13) to connect; Install the small bend door hinge(H*4pcs) to
connect the plate(11) and plate(12) in same way; Install the door handle
(J*4 pcs) with handle screw(I*4 pcs) as shown in figure. Then put the divider
boards(14) into the cabinet.
