Haier UNDERCOUNTER DISHWASHER User manual

HAIER
UNDERCOUNTER
DISHWASHER
Training Presentation

CONTROL PANEL
POWER BUTTON
In to RUN
OUT to STOP

CONTROL PANEL
POWER
IN – Power ON
OUT – Power OFF
(Power Indicator Light will be on)
Must be IN to program
and start wash cycle
Pushing the POWER
button during the wash
cycle cancels all programs

CONTROL PANEL
UPPER WASH
CYCLE
When this cycle is
selected, water is
diverted to the upper
wash arm only.
Dishes must be on
the upper rack only.

CONTROL PANEL
To select Push Select Button
Hi-Temp Wash 1 time
Heated dry 2 times
Upper Wash 3 times
Hi-temp wash and
Heated Dry 4 times
Hi-temp wash and
Upper Wash 5 times
Heated Dry and
Upper Wash 6 times
Hi-temp Wash, Heated
Dry & Upper Wash 7 times
SELECT
Use to select desired
cycles
Corresponding lights will
light

CONTROL PANEL
HI-TEMP WASH
Boosts water temperature
to 161-167 degrees F
Will increase cycle time
depending on temperature
of incoming water

CONTROL PANEL
DELAY
Pressing the delay
button sets the
delayed start up to
9 hours.
Delay time will be
shown in window

CONTROL PANEL
START / PAUSE
Once cycle and options are
selected, push
START / PAUSE
to begin cycle.
Push again to PAUSE the
cycle to open door.
Pressing the POWER button
cancels all preset options

CONTROL PANEL
In the event of a water overflow or leak
• the cycle will end
• a drain cycle will be activated to drain tank
• indicator lamps will flash
• unit will shut off and not restart until
water is removed from base pan

CONTROL PANEL
Power Indicator Lamp
The POWER ON indicator lamp
will remain on at the end of the
cycle until:
1 – The timer is manually moved to
the OFF position
Or
2 – The POWER button on the left
side of the control panel is pushed
to the OFF position.
Manual Control Dishwashers