Haier BC100GS User manual

Beverage Center
Réfrigérateur / Congélateur
Refrigerado / Congelador
User Manual
Model # BC100GS
Guide de l’Utilisateur
Modéle # BC100GS
Manual del Usuario
Para Modelo de # BC100GS
Quality nInnovation nStyle

IMPORTANT SAFEGUARDS
When using this applaince, always exercise basic safety
precautions, including the following:
1) Read all of the instructions before using this appliance.
2) Use this appliance only for its intended purposes as described in this
use and care guide.
3) This appliance must be properly installed in accordance with the instal-
lation instruction before it is used. See grounding instructions in the
installation section.
4) Never unplug your beverage center by pulling on the power cord.
Always grasp the plug firmly and pull straight out from the outlet.
5) Unplug your beverage center before cleaning or before making any
repairs. Note: If for any reason this product requires service, we strong-
ly recommend that a certified technician performs the service.
6) Repair or replace immediately, all electric power cords that have
becomefrasyed or otherwise damaged. Do not use a cord that shows
cracks or abrasion damage along its length, the plug or the connector
end.
7) This appliance is designed built-in use only in an enclosed cabinet.
8) If your old beverage center is not being used, we recommend that you
remove the door and leave the shelves in place. This will reduce possi-
bility of danger to children.
9) Do not operate your beverage center in the presence of explosive
fumes.
10) Do not store foods in beverage center as interior temperature may not
be cool enough to prevent spoilage or may cause bacteria growth.
11) Cabinet edges along stamp/cut-out areas may be sharp. Please avoid
placing hands, fingers, or other appendages near these areas.
12) This appliance is not intended for use by young children or infirm
persons without supervision. Young children should be supervised to
ensure they do not play with the appliance.
NOTE: Ambient operating temperature is between 55˚-90˚F.
SAVE THESE INSTRUCTIONS
DANGER
Risk of child entrapment. Before you throw away your old
beverage center, take off the doors. Leave the shelves in
place so that children may not easily climb inside.
1
English

2
English
Staple your receipt to your manual.
You will need it to obtain warranty service.
Thank you for using our product.
This easy-to-use manual will guide
you in getting the best use of your
beverage center.
Remember to record the model and
serial number. They are on a label
in back of the beverage center.
Model Number
Serial Number
Date of Purchase
TABLE OF CONTENTS
PAGE
IMPORTANT SAFEGUARDS....................................................................1
PARTS AND FEATURES...........................................................................3
INSTALLING YOUR BEVERAGE CENTER .............................................4-7
Unpacking your Beverage Center ................................................................4
Leveling your Beverage Center ....................................................................4
Installation Limitations.................................................................................4
Unit Dimensions.........................................................................................5
Electrical Requirements ...............................................................................5
Use of Extension Cords...............................................................................5
Anti-tip Bracket Installation ..........................................................................6
Door Reversal.........................................................................................7-8
BEVERAGE CENTER FEATURES AND USE .........................................9-10
Initial Set up..............................................................................................9
Temperature Adjustment..............................................................................9
Sabbath Mode ..........................................................................................9
Alarm System ............................................................................................9
Capacity...................................................................................................9
Shelving..................................................................................................10
˚F/˚C Conversion.....................................................................................10
Interior Light ............................................................................................10
Power Button ...........................................................................................10
Normal Operating Sounds........................................................................10
PROPER BEVERAGE CENTER CARE AND CLEANING..........................11
Cleaning and Maintenance.......................................................................11
Power interruptions...................................................................................11
Vacation & Moving care...........................................................................12
TROUBLESHOOTING............................................................................12
WARRANTY..........................................................................................13

3
1. LED Temperature Dispay
2. Temperature Adjustment (up/down)
3. Temperature Set Button
4. °C and °F Conversion
5. Interior Light Button
6. Power Button
7. Door Handle
8. Glass Door
9. Light Switch
10. Front Cover (Toe Kick)
11. Adjustable Leveling Leg
12. Bottom Rack
13. Fold Away Shelf
14. Glass Shelf
English
Parts And Features
1
14
11
12
10 9 8 7
13
2
3 4 5 6

4
English
Installing Your Beverage Center
Unpacking Your Beverage Center
1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the beverage center accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the beverage center.
Leveling Your Beverage Center
• Your beverage center has four leveling legs whch are located in the front and rear
corners. After properly placing your beverage center in its finals position, you can
level it.
• Leveling legs can be adjusted by turning them clockwise to raise your beverage
center or by turning them counterclockwise to lower your beverage center. The
beverage center door will close easier when the leveling legs are extended.
Note: If your beverage center has been titlted for any reason, wait 24 hours before
plugging it in.
Install Limitations
• Do not install your beverage center in any location not properly insulated or
heated e.g. garage etc. Your beverage center was not designed to operate in
temperature settings below 55˚ Fahrenheit.
• Select a suitable location for the beverage center on a hard, even surface away
from direct sunlight or heat source e.g. radiotors, baseboard heaters, cooking
appliances etc. Any floor unevenness should be corrected with the leveling legs
located on the front and rear botto m corners of the beverage center.
• Built-in beverage center need to be ventilated from the front. This feature allows
the unit to be built-in in an enclosed area. The bottom front grill should be clear of
all obstructions. This is absolutely necessary for the air to circulate and for the unit
to operate efficiently. The dimensions for installation are as follows (WxDxH).
Note: Remove the upper hinge cover before built-in the beverage center.

Unit Dimensions
Model W D H
BC100GS 23-7/8" 23-3/4" 34-9/16"
Opening Dimensions
Model W D H
BC100GS 24" 24" 35"
Electrical Requirement
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper
grounding to power the beverage center.
• Avoid the use of three plug adapters or cutting off the third grounding prong in
order to accommodate a two prong outlet. This is a dangerous practice since it
provides no effective grounding for the beverage center and may result in shock
hazard.
Use of Extension Cords
• Avoid the use of an extension cord because of potential safety hazards under
certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
5
English
AWCDZ24S
AWCDZ24S
23-7/8” 25-1/2” 34-9/16”
23-3/4”
DH
34-9/16”
25-1/2”

Anti-tip bracket Installation
1. Take off upper hinge cover with upwards motion. Refer to illustrations below:
2. Take the anti-tip bracket and screws from the accessory bag. Tighten the anti-tip
bracket on the top of the product with screws as follows in the illustration.
Note: Follow instructions properly or you may do damage to product.
3. Pull glass door open and attach the anti-tip bracket to counter by screw as seen
below. Adjustment of the leveling legs under the unit may be necessary for a proper
fit in the cabinet opening. Start with the rear legs (if necessary) before you slide the
unit fully into the opening –rise or lower the rear legs to make the unit fit properly.
Then carefully slide the unit into opening as not to damage accidently cabinetry or
the floor. Then perform the same adjustments to the front leveling legs to bring the
front of unit to the proper level to install the anti-tip bracket and fit evenly under the
counter.
4. Another set of anti-tip brackets for side installation is provided as option when
the counter top is granite and hard to fix by screw. This set of brackets include one
bracket and four screws for installation on left side if the cabinet when the door is
left-open or on the right side of the cabinet when the door is right-open. Below draft
illustrates the installation procedure.
6
English

7
1. Upper hinge hole's cover
2. Hinge cover's plug and screw
3. Upper hinge's cover
4. Upper hinge's screw
5. Upper hinge
6. Front cover (toe kick)
7. Front cover's screw
8. Lower hinge's screw
9. Lower right hinge
10. Door stop spacer
11. Door stop spacer
12. Upper door hole spacer
13. Glass door
14. Door closer
15. Screw
16. Magnetic switch's screw
17. Magnetic switch
18. Lower left hinge (spare part)
19. Screw hole cap
Right Door
Left Door
Door Reversal
English

8
1. Remove lower toe kick (Front cover)
2. Remove plastic plug in the center if hinge cover (#3)
3. Remove screw from center of hinge cover (#2)
4. Remove hinge cover (#3)
5. Remove Square cover on left (#1)
6. Loosen and remove all 3 screws from upper door hinge (#4 and #5)
NOTE: Hold door while loosing and removing upper hinge to prevent fall
and Damaging door as well as bodily injury
7. Lift door and lay door flat on the door
8. Loosen and remove the screws that hold the plastic door closer attached on
the door in place (#14 and #15)
9. Remove upper right hole plastic door spacer (#12)
10. Remove the small screw hole cap in place (#19)
11. Loosen and remove door magnet switch from bottom center of door (#16 and
#17) and reattach it to the top center of door.
12. Loosen and remove the 4 screws that hold the bottom right door hinge in Place
13. Remove bottom right door hinge
14. Loosen and remove the screw that hold the plastic door closer attached to the
bottom right door hinge (#10 and #11)
15. Attach and tighten plastic door closer removed in step 13 to the bottom left
door hinge provided in the accessory bag inside unit
16. Attach and tighten the bottom left door hinge to the unit with the screws
removed in step 8
17. Take door so handle is now on the right side as it is placed in front of you
and lay flat on floor
18. Insert plastic door spacer removed in step 9 into top left hole of door
19. Attach the plastic door closer to the door removed in step 8
20. Align the bottom left hole on the door with the pin on the bottom left door hinge
21. Slide into place gently
22. Take upper door hinge removed in step 6
23. Align pin of upper door hinge with hole on the upper left if door
24. Take the 3 screws removes step 6 and attach them to the screw holes on the
unit and tighten Note: Do not fully tighten yet
25. Make sure top of door is level with top of cabinet
26. Once level, fully tighten screws that hold upper door hinge in place
27. Replace upper hinge cover removed in step 4
28. Tighten hinge cover to unit with screw removed in step 3
29. Replace screw cover plug removed in step 2
30. Replace square cover removed in step 5 to top cover right screw holes
31. Replace the small screw hole cap removes in step 10
32. Attach and tighten toe kick (Front cover) to the unit with the screws removed in
step 1
Steps to Door Reversal
English

9
English
Beverage Center Features and Use
Initial Setup
Once you have plugged the unit into an electrical outlet, let the unit run for at
least 30 minutes to acclimate itself before making any adjustments. The LED
display will show the current internal temperature.
Temperature Adjustments:
• The beverage center can be set to any temperature between 39˚ and 62˚F to
accommodate your storage requirements. To set the temperature hold the "Set"
button for about 3 seconds. You will notice the temperature display blink.
Fig.#1
Sabbath Mode
• Press and hold "^" and "v" at the same time for 3 seconds, buzzer will ring
once, display panel will flash 5 times and stop. This indicates that the unit
has entered Sabbath mode. In this mode, normal cooling operations still take
place (compressor, magnetic valve, fan) but all luminous equipment including
display panel and LED bulb will shut off no matter if the door is opening or
closing. Press and hold "^" and "v" at the same time for 3 seconds, after dis-
play panel flahses 5 times, you cna exit from Sabbath mode.
Alarm System
Door Ajar Alarm- If the door of the unit is kept open for long time and affect
temperature so much , the system will give an alarm, if you want to stop it, press
"SET" button.
Capacity
The capacity of beverage center is 150 cans. The quantity may vary if the type
or the size of the beverage center & can change.