3-Control panel
GB
10
Note: “Smar
●
t Dosing“
The “Smart Dosing” function is retained for all programms after switching the ap
f
●
abricsofteners.
y
If one or both “SmartDosing”indicators are flashing refer to section TROUBLE-
SHOOTING.
ou use powder detergent in compartment 2 in order to avoid overdosing
and excessive foam.
3.5.2 “Delay” (End time delay)
Press this button (Fig. 3.5.2) to start the programme
with a delay. The related symbol and the current end
time will light up. By pressing the button sequentially
end time delay could be increased in steps of 30 min-
6
●
:30 means
end of programme cycle will be in 6 hours and 30 min
u
●
tes. Press “Start/Pause” button to activate the time
del
●
ay. It is not applicable to programme SPIN/DRAIN.
Note: “Delay”
End time must always be longer than programme cycle time. Otherwise operation will
start immediately, although chosen end time could not be reached.
To delete the setting or to cancel the setting process, press the function button until the
Note: Factory settings
there is no special requirement default settings are recommended.
3.5.1 “Smart Dosing“
With this function (Fig. 3.5.1) the dispensing of liquid
detergent and softener from the compartment 1 and
3 of the detergent drawer is performed automatically;
based on laundry quantity, water hardness and degree
of contamination.
This function achieves optimal results, saves washing
agent and protect the environment. A charge lasts for
up to 15 programme cycles.
For deactivating the “Smart Dosing” function touch
the button sequentially until the desired function in
dicator disappears. If no indicator is displayed, manual
dosing is selected.
