7
Inlet Hose
Connect the nut on the inlet hose to the
connector on the water valve.
Connect inlet hose to a water tap with cold,
fresh water.
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
Drain Hose
Use the drain hose bracket to keep the end of the
drain hose retained and prevents the of
water. Don't extend the length of the drain hose; if
an extended hose is required, please consult a
serviceman or plumber.
The height of the drainage outlet must be 80-100
cm. Fix the drain hose to the clip at the back of the
washing machine to prevent it from dropping off.
The drain hose should not be submerged inwater and should be securely fixed and leak-free.
If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the
washing machine will con nuously drain while being filled (self-siphoning).
Conne ng to Power Supply
Before connec ng to the power supply, check:
The socket is adequate for the maximum power of the washing
machine (For safety, fuses in the power circuit should be rated
for no less than 10A).
The voltage should meet the requirement
The power outlet should be capable of accep ngthe was hing
machine plug.
Connect the machine to an earthed socket outlet.
There are adjustable feet under the bo om of the washing machine. Before
use, they should be adjusted so that the machine is level. This will minimize
vibr ons and thus noise during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment.Floor should be as stable and
flat as possible.
1. Loose the lock nut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten the lock nut (1) against the housing.
Adjus ng the feet and locking nut
