Halo XT1000 User manual

Laser Range Finder
User’s Manual Model # XT1000

INCLUDED ITEMS
1) Laser Range Finder Unit
2) Carrying Case
3) Lanyard
4) Lens Cloth
5) Product Information Guide
6) CR2 Battery
Laser Range Finder
User’s Manual Model # XT1000
page 2

GETTING STARTED
page 3
1To open the battery compartment cover on the back of the unit pull
up the Tab and turn it to the left, ac-
cording to the compartment door.
The arrows will match up and the
cover can now be removed.
2Once the battery compartment cover is removed insert a CR2
battery with the plus (+) facing down.
+
-

page 4
3To close the battery compart- ment cover align the arrows (the
tabs can only go in one way) then
push down and turn it to the right,
according to the compartment door.
4
Install lanyard strap, Turn unit over to
the bottom side and insert one end of
the lanyard thru the hole. Push “long” end of
lanyard thru the small loop and pull taught.

page 5
5Locate and press the Power button briefly to turn the unit on. 6The LCD will show one of 4 images, depending on what setting was on
when last powered off.
Displays shown are in NormalDistance Mode
Power Button
M

page 6
7
Focusing the Unit. Locate the ad-
justable eye piece, turn left or right
until images are in focus.
SWITCHING BETWEEN
MODES
Pressing the “Mode” button will toggle between the following modes:
1. Normal Distance in Yards
2. AI Distance in Yards
3. Normal Distance in Meters
4. AI Distance in Meters
Mode Button

1
Normal Distance in Yards - When in
this mode, the Line of Sight distance
in yards is the only information displayed
on the screen.
Normal Distance in
Yards mode gives
an accurate normal
distance to target.
Line of Sight Distance is 200 Yards
page 7
2
AI Distance in Yards - When in this
mode, the True Distance in yards
and vertical angle are displayed on the
screen.
AI Distance in Yards
mode compensates
for the angle of in-
cline or decline in
terrain to give an
accurate distance to
target.
Without AI™ Technology = 366 yards
With AI™ Technology = 300 yards
-35

page 8
3
Normal Distance in Meters - When in
this mode, the Line of Sight in meters
is displayed on the screen.
Normal Distance in
Meters mode gives
an accurate normal
distance to target.
Line of Sight Distance is 274 Meters
4
AI Distance in Meters - When
in this mode, the True Distance
in meters and vertical angle are dis-
played on the screen.
AI Distance in Me-
ters mode compen-
sates for the angle
of incline or decline
in terrain to give an
accurate distance to
target.
Without AI™ Technology = 335 meters
With AI™ Technology = 274 meters
-35

page 9
RANGING
Press the Power button one time and re-
lease to start ranging. While measuring
the distance to target being ranged, the
transmitting symbol will blink. When the
unit is done measuring, the data will be
displayed on the screen.
LCD display shown
with Distance in
Yards Mode on.
Note: If target is out of range or a mea-
surement was not obtained the unit will
display “- - - -” on the screen.

page 10
SCAN MODE
To use in “Scan Mode” press and hold
the “Power” button and, “Scan” will then
appear on the screen. As you change
targets the measurements on the
screen will change. Release the start
button to leave Scan mode. Scan mode
can be used in any ranging mode.
LOW BATTERY
If low battery indicator icon appears
on the screen, the battery has a low
charge and should be changed as this
could cause a ranging error.