PAGE 1 OF
REV.
TOOL BOX
BUL10089
A
1
RSLIDE - SERIES ASSEMBLY INSTRUCTIONS FOR
RSLIDE 12, RSLIDE 16, AND RSLIDE 22
HAMMOND
MANUFACTURING
TM
ELECTRONICS GROUP
visit our website @
www.hammondmfg.com
Tape
Measure #2 Phillips
Screw Driver
NOTE:
Assembly shown is typical on
both sides of drawer.
1
55
26
4
6
3
Tapped mounting rails
reffered to in
Steps D and E
(not included)
Pull slide out and
pull loop to separate
inner and outer parts
Drawer/shelf is pre-
drilled to mount slides
typical both sides
See step C
ASSEMBLY INSTRUCTIONS:
A) Separate inner and outer parts of slide (item 1) as shown. Pull loop on
inner part to release from outer part of slide.
B) Fasten inner part of slide with loop to drawer or shelf using 8-32
screws (item 5) and KEP nuts (item 6) thru slide and into appropriate
holes as shown.
C) Adjust mounting rails (item 3) in enclosure to suit the pre-assembled
distance between brackets or if mounting rails are at set distance,
mounting brackets (item 2) on slide assembly can be adjusted. To adjust
loosen 8-32 screws and nuts on slide assembly adjust bracket location and
retighten screws.
D) Mount outer slide and bracket (item 1) to combination rails at desired
location vertically. Secure using 10-32 screws (item 4) thru slide
brackets (item 2) into holes on rails both front and rear. Check
that slides are at even height on both sides. Install drawer/shelf back into
mating slides and push back int o closed position.
ITEM No. DESCRIPTION QTY
1BALL BEARING SLIDE 2
2SLIDE MOUNTING BRKT. 4
3MOUNTING RAIL (NOT INCLUDED) 4
410-32 SCREW 8
58-32 SCREW 8
68-32 KEP NUT 8
PARTS LIST
