
NOTICE:
The SAR limit of Europe is 2.0 W/kg. Device types NAUTIZ X6 has also been tested against this SAR limit.
The highest SAR value reported under this standard during product certification for use at the ear is 0.26W/kg
and when properly worn on the body is 1.309W/kg This device was tested for typical body - worn operations
with the back of the handset kept 0.5cm from the body. To maintain compliance with RF exposure requirements,
use accessories that maintain a 0.5 cm separation distance between the user's body and the back of the
handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure
requirements, and should be avoided.
Working Temperature: -20℃~ +45℃Storage Temperature: -40℃~ +70℃CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
Hereby, [Handheld Group AB] declares that the radio equipment type [NAUTIZ X6] is in compliance with
Directive 2014 / 53 /EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://www.handheldgroup.com
This device complies with Part 22 & 24 and Part 27 of the FCC Rules.
SAR INFORMATION
The SAR limit of FCC and ISED is 1.6 W/kg averaged over one gram of tissue. Device types NAUTIZ X6
( FCC ID:YY3-14246 and IC:11695A-14246 ) has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at the ear is 0.383 W/kg and when properly
worn on the body is 1.120 W/kg. This device was tested for typical body -worn operations with the back of the
handset kept 1 cm from the body. To maintain compliance with FCC and ISED RF exposure requirements, use
accessories that maintain a 1 cm separation distance between the user's body and the back of the handset.
The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly.
The use of accessories that do not satisfy these requirements may not comply with FCC and ISED RF exposure
requirements, and should be avoided.
Charging mode need to operate indoors, please pay attention
to the environment temperature should be -20℃~ +35℃