Haneco PROXIMA-TRI User manual

PROXIMA-TRI
HANECO LED SECURITY LIGHT INSTALLATION GUIDE
For more information
www.haneco.com.au
[phone]
Thanks for choosing our PROXIMA-TRI LED Security light
We strongly recommend that you read this manual carefully before installation.
NOTE: Sensor is sold separately, see
product codes on following page.
Sensor Function
• When the LUX dial is turned to the sun symbol, the light will operate in any light. To have it
operate only when it is dark (less than 10 lux), turn the dial towards the moon symbol.
• The SENS dial adjusts detection distance. The lowest setting is 2m, which can be increased to
12m by turning the dial towards the + symbol.
• The time the light remains on can be adjusted from approximately 10 seconds to approximately
7 minutes.
• Any new movement re-sets the time and delays the moment the light goes o.
The light can stay on for longer time periods by turning the wall switch on and o within one second.
This overrides the sensor and allows the light to remain on when switched on.
To resume sensor mode, switch o, wait 10 seconds and turn the switch back on.
Manual Override Function
Power Source 220-240V a.c. 50Hz
Detection Range 180°
Ambient Light 10-2000LUX (adjustable)
Time Delay Minimum: 10sec ± 3sec
Maximum: 7min ± 2min
Colour Temperature 5000K
Detection Motion Speed 0.6876 - 1.5m/s
Detection Distance 2 - 12m (adjustable)
Working Temperature -20 - +40°
Working Humidity <93% RH
Power Rating 15W per head
IP Rating IP54
Specications
Test
When testing in daylight, set the TIME dial to 10S and the LUX dial to the sun symbol.
After 30 seconds the sensor should respond to presence and turn on and then o after the set
10 seconds.
To set the sensor for night time during the day, turn the LUX dial towards the moon symbol and cover
the sensor to simulate darkness.

PROXIMA-TRI
HANECO LED SECURITY LIGHT INSTALLATION GUIDE
For more information
www.haneco.com.au
[phone]
Fitting Code: PROXIMA-TRI15
PROXIMA-TRI15-W
PROXIMA-TRI30
PROXIMA-TRI30-W
Sensor Code: PROXIMA-PIR-W
PROXIMA-PIR-B
The luminaire must be installed by a professional electrician.
Always switch the power o when wiring the luminaire.
Ensure input voltage conforms to the voltage range of product.
Ensure wires are securely connected.
Before switching on, ensure that all the wiring is correct.
Warranty is void if product is not installed according to the instructions.
WARNING
L
N
Installation
• Turn o the power.
• Unscrew the head screws on the front of the unit and remove the base plate.
• Feed the connection through the aperture provided.
• Fix the base plate to the wall using the screw holes.
• Connect the power source to the “N” (blue wire) ”L” (brown wire) according to the wiring diagram.
• Replace the lamp on the base with the screws, turn on the power.