Hanna Mail Chime User manual

Model MAIL-1 100
User's Manual
Mail ~hirng
How It Works
When the mailboxdoor isopened, the Receiver inthe house will
buzzfour times and display a red
LED light. Pressthe reset
buttonto reset.
Package Contents
Receiver Sensor
(12 volt A23 battery included)
Double faced tape
AC adaptor

STEP 1
1. Remove bottom case by removingthree screws.
2. Hold down on batteryand pull plasticstrip from batteryholder. 1
3. Assemble the case back together.

STEP 2
1. Peeloff the protectivecover on oneside of the doublefaced tape
and stick the tape onthe side of the Sensor for your type of mailbox
as shown below.
2. Peeloff the cover on the other side of the doublefaced tape and
stickthe Sensor on your mailboxas shown below.
Curb Side
Placetop edge of Sensor
towards top of mailbox lid.
Place top edge of Sensor towards
the hinges of the mailbox. Locate
the Sensor at the bottom of the lid.
Slot Type
Placetop edge of Sensor towards
the hingesof the mailbox.

STEP 3
1. Plugthe AC adaptor intothe backof the Receiver.
2. Plugthe AC adaptor intothe wall outlet.
3. Straightenthe antenna vertically.
3
AC Adaptor
Receiver
Trouble shooting
1. Check if you mountedthe Sensor correctly for your type of mailbox.
2. Check if the battery is installedcorrectly.
3. Try movingthe Receiver to a new locationin your home.
FCC ID: RNCMAIL-1100
This devicecomplieswith Part 15 of the FCC rules. Operationof this device is subject to the following conditions: (1) This device
maynot causeharmfulinterference,and
(2) This devicemustaccept any interference received,includinginterferencethat may
causeundesiredoperation.
Caution: Changes or modificationsnotexpresslyappmvedbythe partyresponsiblefor compliancecouldvoid theusehauthority
to operate the equipment.
Hanna Products Inc.
2602 37th Street, Rock Island,
IL 61201
Phone[phone]
[email protected]
PatentNo.6,046,675
Designedin
USA
Made inChina