Harley Benton G112A-FR User manual

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [email protected] DocID: 516818_03.02.2022
EN
Quick start guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include
this quick start guide.
Safety instructions
Intended use
This device is intended to amplify instrument signals with line level for reproduction via
loudspeaker boxes. Any other use or use under other operating conditions is considered
to be improper and may result in personal injury or property damage. No liability will be
assumed for damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not
within reach of babies and young children. Choking hazard! Ensure that chil-
dren do not detach any small parts from the product. They could swallow the
pieces and choke!
Where to use the product
Never use the product
• outdoors
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• next to a heat source or near an open re
• at locations where the unit can become wet
• in places where the product is exposed to strong vibrations.
General handling
• To prevent damage, never use force when handling the product.
• Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use
liquid cleaners such as benzene, thinners or ammable cleaning agents.
Possible hearing damage
With loudspeakers connected, the device can produce volume levels that may
cause temporary or permanent hearing impairment. Do not operate the de-
vice permanently at a high volume level. Decrease the volume level immedi-
ately if you experience ringing in your ears or hearing impairment.
Danger of electric shock caused by high voltages inside
Within the device there are areas where high voltages may be present. Never
remove any covers. There are no user-serviceable parts inside. Do not use the
device if covers, protectors or optical components are missing or damaged.
Danger of electric shock caused by short-circuit
Always use proper ready-made insulated mains cabling (power cord) with a
protective contact plug. Do not modify the mains cable or the plug. Failure to
do so could result in electric shock/death or re. If in doubt, seek advice from a
registered electrician.
Power supply
Before connecting the device, ensure that the input voltage (AC outlet) match-
es the voltage rating of the device and that the AC outlet is protected by a re-
sidual current circuit breaker. Failure to do so could result in damage to the
device and possibly injure the user.
Unplug the device before electrical storms occur and when it is unused for
long periods of time to reduce the risk of electric shock or re.
Possible damage due to installation of a wrong fuse
The use of dierent types of fuses can cause serious damage to the unit. Fire hazard!
Only fuses of the same type may be used.
Possible staining
The plasticiser contained in the rubber feet of this product may possibly react with
the coating of your surface and after some time cause permanent dark stains. In
case of doubt, do not put the rubber feet directly on the surface and use a suitable
underlay if necessary, i.e. felt-pad oor protectors or similar.
G112A-FR
Features
• active full-range at-response open-back box for modern digital
guitar setups (amp modeling and multieect processors)
• upright installation or as tilt-back oor monitor
• lightweigth Class-D technologie
• controls for volume, resonance and presence
• mute control with LED indicator
• LED indicators for signal and peak (L/R)
• wooden housing, with handle
Controls and connections
öINPUT Input
#VOLUME Volume control
$RESONANCE Resonance control
%PRESENCE Presence control
ö # $ % & ' ( )
Front panel
&SIGNAL LED indicator for signal
'PEAK LED indicator for peak
(MUTE Button and LED for muting
)ON - POWER - OFF Main switch

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [email protected] DocID: 516818_03.02.2022
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your lo-
cal waste disposal facility.
EN
G112A-FR
Technical specications
Speaker 1×12" speaker
1×1" compression driver
Input connections 1×1/4" jack socket
1×XLR (balanced)
Output connections 1×XLR (balanced)
Input impedance 20 kW (balanced)
10 kW (unbalanced)
Input sensitivity Line 1 V (RMS)
Input 200 mV (RMS)
Output power LF 100 W (RMS) @ 8 W
HF 10 W (RMS) @ 8 W
Frequency response 100 Hz ... 20 kHz, –15 dB
Sound pressure level (SPL), max. 121 dB / 127 dB (Peak)
Dispersion angle (H×V) 30 °×110 °
Total harmonic distortion (THD) 0.5 %
Wire connection PIN1: earth / PIN2: signal+ / PIN3: signal–
PIN1: signal+ / PIN2: signal– / PIN3: earth
Power consumption max. 100 W
Power supply 230 V 50 Hz
Fuse 5 mm × 20 mm, 2.5 A, 250 V, slow-blow
Dimensions (W×H× D) 482 mm×448 mm×301mm
Weight 14.2kg
Ambient conditions Temperature range 0 °C ... 40 °C
Relative humidity 20 % ... 80 %
(non-condensing)
Controls and connections
*IEC chassis plug C14 with fuse holder
+LINE IN Line input
,GROUND Slide switch for grounding
-LINE OUT Line output
PUSH
* + , -
Rear panel