Harman JBL Basspro Nano User manual

Owner's Manual -
Betjeningsvejledning -
Bed~nungsan~~ung -
r
I" Manual del propietario Ell
Kayttoopas -
Mode d'emploi -
Manuale d'istruzioni
1111
Gebruikershandleiding -
~
Bruksanvisning
Ill
~~
Bruksanvisning -
Kullamc1 K1lavuzu
-
PyKOBOACTBO nonb30BarenR
-
fflP-fM m
At~At ~~Ai
-
Panduan Pengguna -

ABOUT THE MANUAL
This manual displays general Owner's Manual guideline. However,
please note that proper installation ofmobile audio components
requires qualified experience. If you do not have the knowledge
and tools to successfully perform this installation, we strongly
recommend consulting an authorized JBLdealer about your
installation options. Keep all instructions and sales receipts for
reference .
WHAT'S IN THE BOX
~
~
lX
lX
~, l
ms
BX 2X 4X
1X
Pl = z-; 1111 ~ 00
lX
4X
lX
MOUNTING THE BASSPRO NANO
Recommended location: underthe passenger seat
..
T l
~
' I I
\ ! I
~
~
' '
I
NOTE: Before securing the BassPro Nano with mounting screws,
check beneath the mounting surface to ensure you will not
puncture fuel lines, brake lines, or any vehicle wires.Also ensure
that the BassPro Nano will not interfere with seat operation or
wiring, orblock undersea! heater/air conditioning vents .
WIRING FOR POWER AND GROUND
@ - . -- ~ -- @
a: ' ~@~ e
@
Ground
(block)
+12V ( l!d )
~ ' --
~ ~ @
11,motelum-Gn(blue ) to
.... .......
-
....
~§) ...
ifttnnirbtstmol(Mout :° :: ~~g&
0-Sground( -) ....,
WIRING FOR AUDIO SIGNAL
Line-level from afterrnarket stereo
L,lt lint outp,t
( fn>m"""' )
lllghl illt outp,t
, ,..,. ...... ,
UII '--'_..
- ....
e .= ._. _ e_
Al/TO
TURN 11N
@
• OFF
nrii!l.
~ea
-- -
~ e
~e
@
@
@
NOTE: When connecting an aftermarket stereo to the BassPro
Nano's line - level inputs and remote turn-on wire, set the
AUTO TURN ON button toOFF.
Speaker-level from factory oraftermarketstereo
AUTO
TIJ RNIIN
@)
• ON
Harness high - level input wire guide
White/White with black stripe
Gray / Gray with black stripe I
Left + / Left -
I Right +/ Right -
Im

ID
Note: When connecting a factory oraftermarket stereo to the
BassPro Nano's speaker-level input s, set the AUTO TURN ON
button to ON.
SETTING GAIN, ADJUSTING PHASE, LOW-
PASS FILTER, AND BASS BOOST
GAIN
ce
M IN MAX
PHASE
@
• o·
•1 80 °
LOW PASS
FILTER
ce
50Hz 150Hz
BASS
BOOST
ce
0 +12 d8
1. Start with GAIN cont rol set to minim um,
and th ecrossover control rotated midway.
2. Choose music with substanti al bass
content and turn the volume control on
your receive r to ¾ of its total output.
3. Adjust the GAIN control clockwise,
listening carefully to the bass output. If
you hear distortion, turn the GAIN control
counterclockwise to decreasethe GAIN.
4. Switch t he PHASE back and forth to
determine which setting provides the most
clean bass output.
5. Adjust the LOW-PASS FILTER control
until the BassPro Nano pl ays only low-
frequency information - you should not
hear elements such as vocals coming from
the woofer.
6. Adjust the BASS-BOOSTcontrol
clockwise orcounterclockwise to suit your
taste.
CONNECTING THE REMOTE BASS
CONTROL MODULE
© ':'
, -- ~ ... - © nlil\, ©
□
~ -R-
~-e
. . .
:::.
u:=-
. © e
ee
.........
·, • ~, --
. ... ... ·--
~
e
©
l_l! ..... ~
©
~
HARMAN
HARMAN International Industries,
Incorporated 8500 Balboa Boulevard,
Northridge, CA 91329 USA
www.jbl.com
~
SPECIFICATIONS
• Drive r Complement: 6" x 8" (152mm x 203mm) woofer
• Amplifier Power Output: 1 OOWRMS, 200W Max
• Frequency Response: 30 Hz -150 Hz
• Fuse: 15A
• M aximum Current Draw: 13A
• Quiescent Curren t Draw: <600 mA
• Input Sensitivity: 0.1 V - 4.0V low-level input; 0.25 V- 10V
high-level input
• Crossover Frequency: 50 Hz -150Hz
• Crossover Slope: 12 dB/octave
• Bass Boost: 0 dB to +12 dB @ 50Hz
• Dimensions (L xW x H): 10-1/4" x 7-11/16" x 2-15/16"
(260mm x 195mm x 74.6mm)
• Weight: 7.78Ibs. (3.53kg)
TROUBLESHOOTING
No audio and POWER indicator is off
• No voltage at BATT+ and/orREM terminals, or bad orno
ground connection. Check voltages at amplifier terminals with
VOM.
No audio andPROTECT indicatorflashes every 4 seconds
• DC voltage on amplifier output. Amplifier may need service; see
enclosed warranty card for service information.
No audio and PROTECT and POWER indicators flash
• Vo ltage less than 9V on BATT+ connection. Check vehicle
charging system.
No audio andPROTECT indicator is on
• Amplifier is overfleated. Make sure amplifier cooling is not
blocked atmounting location. Or, there may be voltage greater
than 16V (or less than 8.5\/) onBATT+ connection. Check
vehicle chargi ng system.
Amplifierfuse keeps blowing
• The wiring is connect ed incorrectly orthere is a short circuit.
Check wiring connections.
Distorted audio
• GAIN is not set properly. Check setting. Check wires for shorts
or grounds. Amplifier or source unit may be defective.
Music lacks dynamics or "punch."
• Ifusing speaker-level inputs, check connections for proper
polarity. Switch PHASE back and forth between 0° and 180°
and leave on setting with best sound.
Engine no i se -whining or clicking -i n system when the
engi ne is on
• Amplifier ispicking up alternator noise. First, check ground
connection on the amplifier - aloose or improper ground is
one of the main causes for noise. Turn down GAIN. Move RCA
audio cables away from power wires. Installing an alternator
noise filter on power line between battery and alternator might
also be necessary.
© 2019 HARMAN International Industr ies, Incorporated. All rig hts reserved.
JBL is a trademark of HARMAN Internat i onal Industries, Incorpo ra ted ,
reg is tered in the United States and/or other countries. Features, specifications
and appearance are subject to change without notice.

Deep Bass Without Taking Up Space.
JBL’s BassPro NANO delivers deep bass and takes up little space. JBL’s smallest powered
subwoofer can be hid in the most compact of locations and deliver exceptional performance
to any car audio system. Its rugged all-die-cast aluminum enclosure with anodized textured
matte black finish, which looks great. Powered by a 100 Watt Amplifier, BassPro Nano delivers
punchy, tight bass you would expect from JBL, all while running cool and drawing minimal
current from your vehicles charging system.
Features
Big Bass, Small Space
Intelligent Electronic Design for Reliable
and Extraordinary Performance
Die-Casting Aluminum Enclosure Design
Bass Volume Remote Control
Ultra-Compact Under Seat Powered Subwoofer System

HARMAN International Industries, Incorporated
8500 Balboa Boulevard, Northridge, CA 91329 USA
www.jbl.com
© 2019 HARMAN International Industries, Incorporated. All rights reserved. JBL is a trademark of HARMAN International
Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance are
subject to change without notice.
Features and Benefits
Big Bass, Small Space
JBL BassPro Nano delivers bumping bass and takes up little space. The on-board 100Wrms
amplifier has been performance matched to subwoofer to deliver the amount of clear,
tight bass.
Intelligent Electronic Design for Reliable and Extraordinary Performance
The BassPro Nano employs high-pass filters and limiters that deliver exceptional at-the-limits
performance.
Die-Casting Aluminum Enclosure Design
The rugged all-die-cast aluminum enclosure design in anodized textured matte black not only
minimizes size but also eliminates rattles to deliver clear bass from tiny space.
Bass Volume Remote Control
Bass Volume Remote control is included to let you adjust the sound from the driver’s seat.
What’s in the box:
1x Under seat subwoofer
14x Screws
4x Small metal plate
1x Wiring harness
1x Bass volume remote control (with cable)
1x 15A Fuse
Technical Specifications:
Driver Complement:
6" x 8" (152mm x 203mm) Subwoofer
Amplifier Power: 100Wrms; 200W Max
Frequency Response: 30Hz – 150Hz
Fuse: 15A
Maximum Current Draw: 13A
Quiescent Current Draw: <600mA
Input Sensitivity:
0.1V – 4.0V Low-Level Input;
0.25V – 10V High-Level Input
Crossover Frequency: 50Hz – 150Hz
Crossover Slope: 12dB/octave
Bass Boost: 0dB to + 12dB @ 50Hz
Dimensions (L x W x H):
10-1/4" x 7-11/16" x 2-15/16"
(260.0mm x 195.0mm x 74.6mm)
Weight: 7.78 lbs (3.53kg)
Ultra-Compact Under Seat Powered Subwoofer System