Harmopool Solar Shower User manual

0
Produced by:
Zwembad BVBA
Industrieweg 9
3190 Boortmeerbeek
Belgium
www.harmopool.eu
Manual solar douche 20 liter

1
Congratulations on the purchase of the Harmopool Solar Shower. During the production of this
product, its quality was the most important aspect. It is highly recommended to read the manual
beforehand in order to expedite the installation.
When questions arise, please contact your supplier or visit our website for more information:
www.harmopool.eu

2
Installation instruction
1. Place the shower at a location with a lot of exposure to sunlight.
2. Connect the showerhead to the black pipe.
Note: Please preform the act with your hand instead of with a wrench. Do not forget the
sealing.
3. Screw the foot of the shower into a wooden or concrete floor, by using the 4 bolts, nuts and
sealing. Use a wrench to connect the foot to the floor.
4. Place the O-ring the in lower part of the pipe of the shower. Place the top half on the lower
half of the pipe of the shower. Connect the 2 parts by turning the sealing ring clockwise.
Note: The valve and showerhead should face the same direction.
5. Connect the hose to the inlet of the shower and connect it to the water supply afterwards.
First start-up
1. Turn the valve on and put it on “hot” (red).
Note: By filling the pipe whilst the valve is “hot”, will ensure that there will be no air left. This
procedure is only necessary during the installation.
2. Turn the water supply on. It will take approximately 2 minutes to will the shower.
3. When the water starts to run through the showerhead, please turn the shower off. The water
in the shower will start to warm up.
4. Depending on the weather conditions, it can take up to 1 or 2 hours until the water has been
warmed up.
5. Place the valve on cold (blue) before you open the valve, in order to prevent burns. Change
the setting according to your preference afterwards.
Attention: With a lot of exposure to sunlight, the water in the pipe can warm up to 60°C.

3
Winter-ready
1. Turn off the water supply and disconnect the hose from the shower.
2. Turn on the valve of the shower in “hot” (Red) and let the water run for 4-5 minutes until the
pipe is empty.
Note: Do not change the setting of the valve. This prevent the pipe from going empty.
3. Place the shower inside on a warm and dry location during the winter.
Warnings
1. DO NOT USE SALT WATER OR ANTI-FROST PRODUCTS
2. RECOMMENDED WATER PRESSURE: 3.5 BAR
3. START THE SHOWER IN THE “COLD” POSITION (BLUE) TO PREVENT BURNS.