Hauslane Chef WM-730 Series User manual

WM-730 Model Series
USER MANUAL

Safety Information
1.
2.
3.
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
To avoid damage and noisy and/or unbalanced impellers,
keep drywall/construction dust, etc. off power unit.
Mount your range hood so that the bottom of the hood is
24" to 30" above the cooking surface. The minimum hood
distance above cooktop must not be less than 24"; any
installation less than 24" may cause overheating and cause
damage to the range hood, HAUSLANE does not warrant
this improper installation.
4.
5.
6.
7.
8.
Two to three installers are recommended because of
the larger size and weight of this hood.
sure to duct air outside. Do not exhaust air into spaces
within walls and ceiling or into attics, crawl space or
garages.
Because of the high exhausting capacity of this hood,
you should make sure enough air is entering the house
to replace exhausted air by opening a window close to
or in the kitchen.
Use with approved cord-connection kit only.
for further information and requirements.
CAUTION
Before installing your range hood, read the entire instruction
manual. Installers, leave this manual with the homeowner.
Use this range hood only in the manner intended by the
manufacturer. If you have the questions, contact Chef Kitch
at 1-800-929-0168 or email at [email protected].
Before servicing or cleaning, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
Installation work and electrical wiring must be done by
standards.
equipment to prevent back drafting. Follow the heating
equipment manufacturer's guidelines and safety standards
such as those published by the National Fire Protection
and the local code authorities.
When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
Do not use this unit with any solid-state speed control
device.
1.
2.
3.
4.
5.
6.
7.
8.
This unit must be grounded.9.
1.
2.
3.
4.
Never leave surface units unattended at high settings.
Boil overs cause smoking and greasy spillovers that
may ignite. Heat oils slowly on low or medium settings.
Always turn hood ON when cooking at high heat or
Clean ventilating fans frequently. Grease should not be
Use proper pan size. Always use cookware appropriate
for the size of the surface element.
WARNING
SUITABLE FOR USE IN HOUSEHOLD COOKING AREA
ONLY. TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY, OBSERVE THE FOLLOWING:
TO REDUCETHE RISK OF A RANGE TOP GREASE
FIRE:
2.
3.
4.
NEVER PICK UP A FLAMING PAN as you may be
burned.
DO NOT USE WATER, including wet dishcloths or
towels. This could cause a violent steam explosion.
Use an extinguisher ONLY if:
A. You own a Class ABC extinguisher and you know
how to operate it.
*Based on "Kitchen Fire Safety Tips" published by
NFPA.
WM-540 USER MANUAL
2
WARNING
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING*:
1.
or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS. IF THE FLAMES DO NOT GO OUT
IMMEDIATELY, EVACUATE AND CALL THE FIRE
DEPARTMENT.

Parts Supplied

3
WM-730 USER MANUAL
3
Uy Knife
Measuring
Tape
Marker
r Pencil
Level
Pwered
Drill
Flat & Phillips
Screwdrivers

(For dry wall or
sheet rock only)
D
6
WM-730 USER MANUAL
4
WM-730 USER MANUAL
4

WM-730 USER MANUAL
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
5

WM-730 USER MANUAL
6
WM-730 USER MANUAL
6

WM-730 USER MANUAL
•
•
•
•
•
•
•
•
•
7

Determine and mark the center line n the wall where the range will be installed. Make sure there is
clearance within the ceiling  wall exhaust vent.
Due tthe weight and size f this unit, please make sure that the system rbeing used is
stable and secure in the wall ceiling.
Put a thick, r range tdamage r dirt. 
any the area when installing.
Mark the f the bracket (if used) and supply cable
the wall ceiling behind the chimney Use drill and saber saw  saw cut
 cable and (see Venng Requirements and Electrical Requirements, Pages
).
If the install vent system (see Venng Methods, Page ). Use caulking  seal 
wall  
main electrical supply, prepare and run electrical wiring ceiling r wall.
Install a within reaching distance range assembly. DO NOT 
Assemble the duct adapter the range Place the duct adapter gasket  the 
perimeter rectangular side duct adapter; place the rectangular side duct adapter 
the range  duct, aligning the screw fasten the duct adapter the range using the
supplied hardware: “D” screws.
Severe Injury
WM-730 USER MANUAL
8
WM-730 USER MANUAL
8

Upper Chimney
Munng Bracket
Qty: 6 PCS
(For dry wall or
sheet rock only)
Qty: 4 PCS
Upper Chimney
Duct wrk and electric
wiring reg
Lwer Chimney
6” und Duct (exhaust)
Qty: 6 PCS
Mtr Husing
Electric Circuit 
Note: Type “A” anchors are
designed for for dry wall or
sheet rock. Not to be used
with any other types of walls.
Wall Munt
Range Hd
Hazard of electrical shock!
 centerline and side measurements 
Measure the distance and the
f range and a distance f
2” 3 ”.
*Due to different ceiling height configuraons,
recommended height may not be applicable. Use removable tape,
pencil or erasable marker to mark your ideal installaon.
Make sure the range is level,   and   against  
WM-730 USER MANUAL9

Figure 3A
Figure 3B
Figure 4
Mark the  f the  shaped hanging
bracket   the wall as  in Figure 3A and
Figure 3B.
Figure 3
Use that as reference twhere 
want  upper chimney installed and where the

Place the bracket squarely the range
 level it and mark the f the 
bracket n the wall.
Safely place aside all equipment and review all marked
drill Review fastening hardware tbe
used.   type f wall:
where the structural
studs structural  screw
directly  the structural studs r
with hardware that meets are exceeds the 
hardware, with at least 1”  thread engagement.
where the structural
studs structural are
the range  structural studs is highly
If stud are  available, it is
build a  structure behind the
sheet the best weight  
are used, ensure their hanging capacity exceeds the
weight the range  hardware, and 
usage 
Use designated  screws 
  meet exceed the 
hardware   
  screw manufacture.
(if using  hardware)
the wall (as
in Figure 4)    marked 
  the range    fasten (2)
 Type “B” screws  the 
Secure upper
support frame
WM-730 USER MANUAL
10

 wall range  island
the rear panel range 
(against the wall) is plain sheet metal and
can be drilled and screwed the wall  
  any
wires, any wire harnesses,  
(if using
hardware)
First, install the duct tube 
and then extend the 
6 inches f extra 
Then, cut excess  Install the the
range  duct adapter. Use 
tape r fastening devices.
Plug in the 
DO NOT turn main  supply is
If a test is desired be 

lear and ensure is safe. Then
supply unit and test 
Please ensure  SHUT OFF POWER SUPPLY
 and 
Figure 4A
D
RYWALL
Figure 5
Fasten mounting
bracket
Slide up and secure
upper chimney to
mounting bracket
Hold in position and
secure lower chimney
to range hood
WM-730 USER MANUAL
11

Figure 6
Figure 7
Having the hardware readily available, align
the upper chimney with the pre- installed (upper
chimney) bracket and then screw the
hardware the chimney  the 
bracket. any  wrapping.
any chimney piece at a
with the upper chimney. Ensure the
chimney pieces are fully  
any step.
the f the  chimney 
Pull, stretch  the rear   the chimney 
it is  larger than the upper chimney 
Carefully  wrap the the
upper chimney and range 
Screw in the hardware the 
chimney the range  any
 wrapping.
Install aluminum stainless steel 
then check the the range 
any  wrapping. Use
stainless steel cleaner any prints 
marks.
WM-730 USER MANUAL
12
WM-730 USER MANUAL
12

How to Use Your Range Hood
EASY ACCESS KNOB CONTROL
CAUTION: For halogen lamps never touch bulbs during
operation; they can get very hot.
Now that your range hood is installed, it’s time to learn how to
use it. It is very simple to use and is operated entirely using the
front control panel.
Power Speed Indicators Lights On/Off
WM-730 USER MANUAL
13

•
•
•
•
•
•
•
•
•
•
WM-730 USER MANUAL
14

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
WM-730 USER MANUAL
15
•This range hood uses 120V, GU10, 3W LED light
bulbs.
•Switch off power and allow 5 minutes for the
lights to cool down.
•Remove the light bulb by turning to the left
•Replace with a new light bulb by aligning
the base with the range hood socket and
turning it to the right until the light bulb is
locked in position.
•Check if the new Lamp is working properly.

Any defects or damage to light bulbs
Improper installation not in accordance with the instructions
Dents, bumps, and scratches incurred during shipping,
handling, or installation
Damage caused by failure to follow care and cleaning
guidelines, including damage caused by the use of abrasive
cleaners
Alterations made to the unit by the purchaser or installer
and normal wear
Bends and warping caused by forced connections,
installation
This range hood is warranted to the original purchaser to be
from the date of purchase.
Our obligation shall be limited to the repair or replacement of
tion, to be defective under normal use and service during the
warranty period. We may issue credit in the amount of the
of this product that is not traceable to a defect in material or
workmanship is not covered by this warranty. These non-war-
rantable items include, but are not limited to:
A thorough inspection must be made before installation and
any damage must be promptly reported. We will not be liable
for failures or damage that could have been discovered or
avoided by proper inspection and testing prior to installation.
Incidental repairs that would involve a minimum of time and
effort on behalf of the purchaser will not be considered
warranty work and no compensation will be deemed forth
coming.
This warranty is non-transferable and shall be voided if the
unit is removed from its initial installation or if it is not installed
following the instructions.
Under no circumstance shall we be held liable for
personal injury or property damage resulting from
improper installation or use of this product. We will not
be held liable for inconvenience caused by loss of use of
this product, costs incurred for labor or materials, removal
and installation of replacement units, or any other
incidental or consequential damages. Costs relating to
obtaining access for repair or replacement are the
responsibility of the user.
Description of the range hood
Proof of sale
Details regarding the defect
comply with this stipulation will make this warranty null
following the receipt of a claim in which to inspect the
product. We assume no responsibility for labor costs,
removing or replacing a previously installed product,
transportation, or the return of a product.
Warranty Information
CALIFORNIA RESIDENTS ONLY
WARNING:
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
WM-730 USER MANUAL 16
This warranty does not extend to commercial and
institutional installation or use.
Warranty Claim Procedure
If a claimable defect occurs, please contact our customer
service team at 1-800-929-0168
[email protected]
Before you make your claim call, please ensure that you
have:

Extended Warranties
If you are interested in an extended warranty, sign up on our website at www.hauslane.com
Parts and Accessories
If you need replacement parts or accessories, visit www.hauslane.com
Contact Us
We’d be happy to answer your questions or resolve any issues you may have.
Phone: [phone]
Email: [email protected]
Find Us and Connect with Us
Contact Hauslane
WM-730 USER MANUAL
17