Hayward GLX-FLO-RP User manual

\
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Hayward Industries
400 Connell Drive, Suite 6100
Berkeley Heights, NJ 07922
Phone: [phone]
www.hayward.com
GLX-FLO-RP
Replacement Flow Switch
Owner’s Manual
092010E RevC
GLX-FLO-RP-25
Contents
Introduction............................................1
Installation..............................................1

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
1
Introduction
Compatibility
Replacement flow switch for use on the following chlorinators:
Aqua Rite Electronic Chlorine Generators (all models)
Naturesoft Water Purification System (all models)
Mineral Springs (all models)
Aqua Trol Above Ground Pool Automation (all -HP models)
SplashCLEAR (all models except -RJ versions)
See the reverse side for the warranty on this part.
Installation
Digital Display Units:
1. Unscrew flow switch from the plumbing tee by turning it counterclockwise until the switch is
completely out of the tee.
2. Carefully bend rubber flaps if applicable and insert into the tee making sure not to damage the
switch.
3. Tighten switch to make sure there are no leaks. Do not over-tighten!
4. Make sure that the arrows on the flow switch are facing in the direction of water flow.
5. Plug the flow switch into the connection on the bottom of the electronics unit.
Non-Display Units: (Using 4 conductor wire)
Follow steps 1-4 above, then:
5. Cut the connector off the 4 conductor cable and strip back the jacket.
6. Cut off the yellow and black wires on the 4 conductor cable -- they are not used.
7. Strip the green and red wires and connect to the terminal strip in the electronics unit per the
wiring diagram on the inside of the door. (see below)
Yellow
(not used)
Black
(not used)
Green
Red
Electrolytic
Cell
Temperature
Sensor Flow
Switch
Flow Switch with
4 conductor wire

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
Non-Display Units: (Using 2 conductor wire)
Follow steps 1-4 on the previous page, then:
5. Cut the connector off the 2 conductor cable and strip back the jacket.
6. Strip the red and black wires and connect to the terminal strip in the electronics unit per the
wiring diagram on the inside of the door. (see below)
Black
Red
Electrolytic
Cell
Temperature
Sensor Flow
Switch
Flow Switch with
2 conductor wire

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
For further information or consumer
technical support, visit our website at
www.hayward.com
Hayward is a registered trademark of Hayward Industries, Inc. © 2019 Hayward Industries, Inc.
All other trademarks not owned by Hayward are the property of their respective owners.
Hayward is not in any way affiliated with or endorsed by those third parties.