HBM SOMAT XR EX23-R User manual

EX23-R Quick Start Guide
WARNING
Keep protective caps in place when connectors are not in use.
Opening the unit invalidates the warranty and IP rating. There are no user serviceable components inside the unit.
Do not apply more than 10 psi water pressure to the unit.
© HBM, Inc. All rights reserved. All details describe our products in general form only.
They are not to beunderstood as express warranty anddo not constitute any liability whatsoever.
Americas: HBM,Inc. · 19Bartlett Street · Marlboro · MA 01752 · USA · Tel.:[phone] · Email:[e-mail]
Asia: Hottinger Baldwin Measurement (Suzhou) Co., Ltd. ·106 Heng ShanRoad · Suzhou 215009 ·Jiangsu · China
Free hotline: [phone] (onlyin China) · Tel.: [phone] · Email: hbmchi[email protected]om.cn
Europe: Hottinger Baldwin Messtechnik GmbH · Im Tiefen See45 · 64293 Darmstadt · Germany
Tel.: [phone] · Email: i[email protected]
measure and predict with confidence
A4159-1.0en SO-269-1000936
EX23-R Quick Start Guide

EX23-R PoE Switch
1. Connect the 1-NTX003 power supply or 1-KAB2115 power
pigtail cable from the power connector on the EX23-R to a
10-36VDC power source.
NOTE
Connect only the red and black wires of the 1-KAB2115 cable.
Do NOT use a 1-KAB2110 cable to power the EX23-R from the CX23-R.
Configuring the EX23-R
1. Connect a PC to any open port using a
1-KAB2106 cable.
2. Open an internet browser and navigate to:
oIP Config: 192.0.2.1/ip_config.htm
oFirmware: 192.0.2.1/upload.htm
3. Log on using the default credentials:
ousername:
admin password: (blank)
EX23-R Status LEDs
Power LED Description
Off Power input not in range
On Unit is powered
Flashing (2 Hz) Power error
Flashing (8 Hz) Firmware update
Severalissues can cause a power error:
oOver temperature
oOver voltage or over current input power
oInternal power supply not working
Ethernet LED Description
Off No link
Green Gigabit link is up
Orange 10 or 100 Mb link is up
2. Connect the desired devices to the Ethernet ports using
1-KAB2100, 1-KAB2106 or 1-KAB2107 Ethernet cables,
depending on the device.
CAUTION
Drawing PoE power lowers the maximum operating temperature. Please
refer to the data sheet for the exact de-rating specifications.
Setting up the EX23-R The EX23-R is designed to be used straight out of the box.
NOTE
To reset to factory defaults, jumper port 1 to port 2 using
a 1-KAB2107 cable and power cycle the unit.
EX23-R Quick Start Guide EX23-R Quick Start Guide