Heatmaster ENVIRO Use and maintenance manual

MANUAL CONTROL GUIDE
www.heatmaster.com.au
enviro
STEP 1
Ensure that the power supply to the rebox is switched on.
STEP 2
To ignite your Enviro press the power on/off button(top left). This will begin the ignition
sequence which will purge the air from the rebox for approx. 30 seconds before
igniting the burner.
STEP 3
The heater will start in the low setting for approx 2 minutes before automatically
jumping to the maximum setting.
STEP 4
To reduce the fan/ame setting press the top right button. To increase the fan/ame
press the bottom right button.
*The fan and ame are connected which means that reducing or increasing the
ame will also reduce or increase the fan speed.
STEP 5
to turn your Enviro off, simply press the on/off button.
PLEASE NOTE:
Fan will continue to run until rebox cools down.
ON/OFF – –
POWER FAN FLAME
+ +
This is a basic guide only for complete instructions on the use of your Enviro refer to the Customer operating
information & instruction guide along with the 7000 series thermostat user manual.
* It is important to note that for
15 minutes after using your Enviro remote,
a signal is transmitted from the thermostat which
overides the manual controls. To avoid this you can simply turn
off the power (at the isolation switch) for approx. 2 min before using the manual controls.

REMOTE CONTROL GUIDE
www.heatmaster.com.au
enviro
STEP 1
Ensure that the power supply
to the rebox is switched on.
STEP 2
To ignite your Enviro press and release
the power (PWR) button. Ensure that
your set temperature is above the room
temperature. This will begin the ignition
sequence which will purge the air from the
rebox for approx 30 seconds before igniting the
burner.
Ensure that your remote is set to MANUAL (this will be
displayed at the bottom of your LCD screen once you
press the PWR button). To switch between MANUAL and
AUTO press the A/M button. – for Auto programming and time
setting refer to the 7000 series thermostat user manual.
STEP 3
To adjust the fan/ame setting simply use the up or down button to change the set
temperature.
*The fan and ame are connected which means that reducing or increasing the
ame will also reduce or increase the fan speed.
- Next: to set the temperature you will notice a small 1, 2, or 3 which indicates the
level of the fan & ame. Level 1 being the lowest and 3 the highest. The picture of
the ame will also adjust to indicate which level you are on. As you increase the gap
between the set temperature and then room temperature the level of the ame & fan
will increase. As the room temperature gets closer to the set temperature the ame &
fan will modulate down to a lower level.
Once the room temperature has reached your set temperature the re will turn off
until the room drops below the set temperature again.
STEP 4
To turn off your Enviro press the power button.
PLEASE NOTE:
Fan will continue to run until rebox cools down.
This is a basic guide only for complete instructions on the use of your Enviro refer to the Customer operating
information & instruction guide along with the 7000 series thermostat user manual.