Step 5
Clip the receiver front onto the back plate.
Pairing the Thermostat
To pair the thermostat with the receiver, follow these steps;
On the receiver;
Press the Pairing bu!on.
The Communica"on LED will comeon
On the thermostat;
Press Prog
Press Setup
At the top of the LCD, you will see 01.
Use the up arrow toselect 05 to enter the pairing func"on
In the centreof the LCD, you will see 01. This is the channel
address. The default se#ng of 01 can be used in most cases, but
should be changed when a conflict is detected between other RF
devices.
3
