heimgard Combustible Gas Detector User manual

Quick start guide version 1.0
Requires a heimgard hub
Combustible Gas
Detector

What is in
the box
A.
Gas Detector
B.
Metal
pin

Device
overview
C.
Join/Reset
Button
D.
Testing
button
E.
LED
Indicator
F.
Gas convection
holes

Connect the device (A) to a wall socket
Open the Heimgard app and follow the steps
listed here to connect to your device:
1.
2.

Insert the metal pin (B) and press join button (C)
for 3 seconds while your app is scanning for the
device
Your device will appear in the Found Devices
list. Click congure to add the device to a
specic room.
The device is precongured as part of your
alarm system and will sound when alarm is
triggered.
3.
4.

Mounting
Before use, conrm whether the gas that is to
be detected is heavier or lighter than air.
If the gas has heavier density than air, install the
device 30-100 cm above the oor with less than
150 cm from the gas source. LPG for example.
If the gas has lighter density than air, install the
sensor install the device 30-100 cm below the
ceiling and less than 150 cm from the source.
Natural gas, manufactured gas, marsh gas, etc.

LED Description
Troubleshooting
Insert the metal pin (B) and press the reset
button (C) for 5 seconds to disconnect the
device from the network. The LED will ash 6
times to indicate successful disconnect.
Standby Solid Green
Warm up Alternate ashing green/red/yellow
Test Alternate ashing green/red/yellow
Sound «Di-di»
Alarm Red Flashing
Sound «Di-di»
Fault Yellow solid
Sound: Long «diiii»

Website: heimgard.com/support
Email: [email protected]
Facebook: facebook.com/heimgardnorge/
Telephone: [phone]
Need help?
Visit heimgard.com for
more information and tips
on how to use.

Important safety
information
1. Read through these instructions and follow accordingly.
2. Clean only with dry soft cloth. Household cleaners and solvents
can damage the nish on your device.
3. Do not install near any heat sources such as radiators, heat
registers, stoves or other device that produce heat.
4. Do not use this device near water.
5. Warning: To reduce the risk of re or electric shock, do not
expose this device to rain or moisture.
6. Do not expose device to dripping or splashing.
7. Protect the attached cables from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point the
exit the apparatus.
8. Only use attachments/accessories specied by the manufacturer.
9. Unplug this device during lightning storms or when unused for
long periods of time.
10. All servicing should be performed by qualied service personnel.
Servicing is required when the device has been damaged in any
way.
11. Operating temperature: -10°C to +50°C
12. Operating relative humidity: < 95% RH (no condensation)
Dispose the product properly at the end of life. This is elec-
tronic waste which should be recycled accordingly.

heimgard.com