HengZeng Technology HT-043 User manual

HT-043 Instruction Manual
The product is a wearable (watch, launch with time function) pet wireless dog
training collar, easy to carry.The control distance is between 100-150 meters. Voice,
vibration, electric shock 3 training mode. A transmitter can train many pets in a same time
with extra receiver, all the receivers should get a same code. A transmitter can train 1-3
pets in a different time, the receiver need get a different code (that is, the first receiver to
get the left side A code, the second receiver to get the middle B code, The three receivers to
get the upper right C code)
Transmitter
MODEL LED light
OK LCD screen
LEVEL/+
DOG/- Dust cap Charging port
1、Adjust Time：Press mode button；hours flash，press LEVEL/+ and DOG/-to
choose correct time，press MODE button again，minutes flash，press LEVEL/+ and
DOG/-to choose correct time
2、Adjust training mode：Press mode number，you can see voice,vibration
and shock shows on the screen

3、Adjust Strength ：in the model of shock and vibration,you can choose
different strength(1 to 4) by pressLEVEL/+
4、Adjust pet：Press Dog button,it will show different dogs-ABC
5、Ok button is used to lauch signal,press OK button,the transmitter will give out 915M
high frequency signal in the mean time,led light will light on;no press ok button,then no
signal,no light
6.Match code,hold LVEL/+ and DOG/- button at a same time,there will be a L shows on
screen,also different dogs ABC shows on the screen,choose the mode the you like,such as
A;Press OK button on the transmitter and press on button on the receiver,green light flash
means code match(when code match,also you can find voice/vibration/shock function on
the receiver)
7.How to charge the receiver:
If the power is lower than 3.3V,there will be a battery flash on the screen,it means you need
charge it;use a 5V,500mah or 1A charger to charge it,when charging it,the battery will
flash,if no flash means full charge
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can
be used in portable exposure condition without restriction.