Heritage Bathrooms CLOSE COUPLED W.C User manual

CLOSE COUPLED W.C
Installation Manual

4B
Remove the wing nuts and lower
the cistern body.
they will be used
plastic washers from the base of
Please keep these components
nearby as
in stage 7.
Please leave the remaining
cistern body should
nuts and washers in place.
Your
resemble that shown in g.3.
Locate the large foam seal and
outlet positioned in the centre.
place this over the plastic cistern
The foam should nish ush with
the cistern base.
Position the cistern body onto
threaded bars should
holes towards
the close-coupled pan.
t smoothly through the two
the back of the pan.
The two
corresponding
into place, keeping it supported
to prevent it falling.
Gently lower the cistern body
Locate the wing nuts and washers removed in stage 2 . Screw
these back onto the threaded bars until nger tight. This will se-
cure the cistern body to the pan.
1
Having completed the cistern’s
the xings on the base.
internals position it to access
23
456
7

in the desired location against
supply and outlet connections.
If required consult a plumber to
Position the close-coupled pan
the wall and align with water
ensure correct xing and to
leaks after installation.
Draw a line around the base of
Also mark the location of the
These will be used as a guide
base of the pan to clearly mark
the final position.
holes on either side of the pan.
for the oor xings.
Mark the two wall xing holes
that the cistern body is still
Then move the pan carefully
inside the cistern body, ensuring
correctly aligned on the pan.
to one side.
Using a 10mm bit, drill the oor
provided.
and tap in the plastic wall plugs
Locate the wall xing kit and
where the cistern body will be
plugs provided
using a 5mm bit, drill the wall
secured.
Plug these two holes with the
(or more appropriate xings
if required).
location, make plumbing
connections and ensure that
proceeding to stage 14.
always be carried out by a
Return the pan to the desired
they are water tight before
We recommend that this process
professional plumber/installer.
caps to the screw head on
either side of the pan.
Attach the two screw cover
8910
11 12 13
14

Locate the wall xing compone-
These require to be assembled
and a thicker rubber
with a metal washer on the
washer on second .
nts for the cistern body.
screw rst
Drive the screws into the wall
place.
plugs to hold the cistern body in
Place the cistern lid into position
on top of the cistern body.
Locate the push button compo-
the cistern internals until tight.
nent and screw this down into
This completes the installation
of the close-coupled WC Pan.
Care and Maintenance
Once installed, ush the toilet 2 or 3 times to ensure it is functioning correctly and check all supply
and waste connections for leaks.
If the toilet fails to remove solids please check the following:
1. You are pressing the correct button
2. The valve has been set correctly
3. There is no obstruction in the W.C outlet or in the connecting soil pipe.
Clean the exterior of your W.C suite with hot soapy water and a cloth.
Do not use harsh abrasives particularly on areas displaying the logo.
15 16 17
18