Highfield PA500 User manual

Highfield Boats
Rollbar Installation Guide
(PA500-760)
RBIG2021V1

Installation Guide: Rollbar
①Red stickers indicate the location of holes for installation. Tear off the stickers and
cut the anti-skid PVC decking to expose the holes. Do not remove the anti-skid fabric.
② Use insulating compound to eliminate corrosion between the aluminum and the
stainless steel screws.
Recommended corrosion inhibitor: Duralac, Tef-Gel, Lanocote
Page 1/3
Corrosion Inhibitor

Installation Guide: Rollbar
③ Secure the rollbar using polyurethane marine grade adhesive such as 3M 5200, Sika
291, Fixtech Fix 15.
④Use a ratchet strap to adjust the width of the rollbar.
.
Page 2/3
polyurethane marine grade adhesive

Installation Guide: Rollbar
⑤Use insulating compound on the M8 stainless steel screws supplied with the rollbar.
Fasten the rollbar to the transom using the screws.
Congratulations, you have successfully installed the rollbar.
Page 3/3
1—Screw M8×40mm;
2—Stainless steel flat washer M8
3—Plastic washer M8
4—Rollbar base;
5
—
Stern plate