Hillrom Welch Allyn 52100 User manual

Welch Allyn®
Models 52100 and 52101 Specula Dispensers
Mounting Instructions
Mat. No. 1202590, 80027531 ver A
Revision Date: 2020-12
Choose the mounting method best suited to mounting surface type:
OR
(over)
To ax unit to a dry, clean, rm nonporous surface (such as
sheetrock) use double-sided tape:
1. Attach 2 pieces of double-sided tape to White Base, keeping outer
release liner in place. Select location on wall.
CAUTION Take particular care to properly locate the
unit at FIRST contact of tape to wall.
2. Remove release liners and press unit firmly against wall in exact
position desired.
3. If necessary, to relocate: Remove from wall by prying under rear
of White Base. Then remove old tape and apply new double-sided
tape (1/16” thick) such as 3M 4466W or equivalent.
To ax unit to a rough, porous surface (such as vinyl
wallpaper) use screws:
1. Mark desired location for top of unit on wall. Measure
down 4" to mark top screw location. Measure down 3" to
locate lower screw.
2. Drive the two screws provided into the wall, leaving
about 1/8" behind the screw head. Depending on the
mounting surface, alternate screws may be needed.
3. Mount unit by fitting the round holes in the rear of
White Base over screw heads on the wall. Then push
downward on unit to secure it to wall.

The 52100 and 52101 Dispensers store the
following Kleen Spec®otoscope specula:
3.0mm Pediatric Size (52133)
4.0mm Adult Size (52134)
5.0mm Large Adult Size (52135)
Pressure sensitive labels (including extras) are enclosed
to identify the size specula you choose to store in each
column. Affix the size desired to the triangular boss of
the tube being used for that size.
3.04.0 5.0
3.0mm 4.0mm 5.0mm
Hillrom Technical Support
Hillrom.com/en/about-us/locations/
© 2020 Welch Allyn, Inc. All rights reserved.
Welch Allyn, Inc. is a subsidiary of Hill-Rom Holdings.