Hisense RQ560N4WB1 Mounting instructions

RQ560N4WC1
FMN431W20C
RQ560N4WB1

16
17
18
19
21

17
18
Water tank(with cover and knob)
Can rack

The water dispenser located in the fridge
door, is for storing drinking water. With this
appliance you can obtain chilled water
easily without opening the refrigerator. You
should be informed of following tips.
Before using
Before using this appliance for the first time,
you should use it as follows.
1. Hold one bottom side of the water tank
by a hand, lift up the opposite side by the
other hand,when the slot of the water tank
2. Hold the two sides of the water tank
tightly, lift up and put out of the water tank.
is off from the guide, change hands to
3. Unscrew the head, then clean head ,lids
and the water tank.
Caution!
Drain the water tank befor you take it down!
repeat these steps.

Warning!
Don’t touch the other parts of the
appliance when filling water, it may
cause the water leakage.
Dispensing water
1.Make sure the cover of the water tank
is fitted on.
2.Close the fridge door and check the
dispenser.
Before you dispense the water, make
sure the lock device is on the “Unlock”
Warning!
The lock is defined as “child lock”.
Don’t push the dispenser lever forward
strongly, when the dispenser is on “Lock”
Caution!
Fill with water up to 3.5L ( which is
suggested) and not above the level.
Otherwise, it may overflow when the lids
We recommend that you fill the water by
the following ways.
1.Remove the small lid and fill water from
the inlet of the larger lid.
2.Remove the cover of the rank, and then
fill water inside directly.
is closed.
situation.
Assembling
After cleaning, please assemble the parts
including the head, water tank and lids as
follows:
1. Put the seal ring in order first ( the seal
2. Hold the two sides of the water tank
tightly, fit the water tank along the guids
4. When you hear clicks by both sides and
the same time the both sides of the waterat
is closed to the door liner, It means the tank
installation is completed.
3. Push the two sides of the water tank
downward as the picture shows.
seal ring
ring can not turn up), then insert the head
into the hole.
guide
slot
head
on the door.
Filling water
Before you fill the drinking water into the
water tank, ensure that the water tank is
steady and in a correct position.
14

appliance, you should dry it by natura
drying or using the dryer. If you have used
the water dispenser for many times, the
water in the receiving tank may drop on the
Cleaning
1.Put the water tank out of the door
carefully and then wash the tank, lid, and
head lightly in water.
2.After you have successfully cleaned the
floor, which may make your floor wet, and
you should clean the tank with dry towel
regularly before overflow.
situation, it may damage the mechanism.
Receiving Water
You should use the correct cups to receive
water underneath the water dispenser.
Warning!
Don’t push the dispenser lever forward
without cup, it may cause the water leakage
from the dispenser.
15

16

17

18

19

20