Hisense HA450 User manual

MINI HI-FI System
Model:HA450
USER MANUAL
Read all the safety instructions carefully before use and keep
this instruction manual for future reference

7
7
7
Use the LINE IN/AUX Socket
Speaker socket
7
8
8
8
8
8
9
9
9
10
10
11

FM antenna
Battery
Speaker X 2
Main Unit Remote Control User Manual
Quick Start Guide
Warranty Card
Thanks for your purchase of our product. Please read through this manual before making
connections and operating this product. Retain this manual for future reference.
●Compatible with CD,MP3,CD-R,CD-RW,etc.
●With USB Slot .
●With bluetooth function .
●Full function remote control.
●FM stereo radio tuner.
●Line in(3.5mm)
Note: The player is not compatible with all disc;
Some of the disc could not read, caused by the disc is dirty,disc of poor quality, etc.
Features

HA450 Port
STANDBY/ON
PLAY/PAUSE
PREVIOUS
LINE IN
NEXT
SOURCE
EQ
DISC TRAY
STOP
OPEN/CLOSE
DISPLAY SCREEN
MASTER VOLUME ADJUSTER
FM ANTENNA JACK
SPEAKER OUTPUT
Switch the unit between ON an Standby
mode.
Play/pause playback.
Previous track
LINE IN jack
Next track
Select a play function
Equalizer modes
Disc compartment
Stop play
Open and close the disc compartment
Display screen
Increase/decrease the volume level
Connect to FM antenna
Speaker out terminals (L + R)
USB SLOT USB jack
Front View
Rear View
FM ANTENNA JACK SPEAKER LED OUTPUT
STANDBY/ON
OPEN/CLOSE
SOURCE
DISPLAY SCREEN
PREVIOUS
LINE IN
REPEAT
FAST REWIND EQ
USB SLOT
PLAY/PAUSE
STOP
LED LIGHT ADJUST
MASTER VOLUME ADJUSTER
DISC TRAY
NEXT FAST FORWARD
FAST FORWARD Fast Forward playback
FAST REWIND Fast rewind playback
LED LIGHT ADJUST LED display lighter adjust
REPEAT Repeat mode

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1 STANDBY Switch the unit between ON and STANDBY mode.
2 CD Switch to CD mode.
3 USB Switch to USB mode.
4 FM Switch to FM mode.
5 MEMORY/PRG
PROGRAM(In CD mode)
In stop mode, place a CD and press [PROGRAM] to
access to the program mode. Press the arrows
[ ]/ [ ] to select the desired track and press once
again [PROGRAM] to confirm your selection. Press
[ ] to start program playback.
MEMORY(In FM mode)
After tuning in a new frequency, press [MEMORY]
then select a preferred station by pressing arrows
[ ]/[ ], press [MEMORY] again to confirm and
save it as a preset station.
6 /
Press to return to the previous track.
Hold down for fast rewind playback.
7
Play/pasue playback.
Hold down this button for 3 seconds to disconnect
bluetooth.
8 FOLD-/FOLD+
Press to return/skip the previous/next folder
10 TUN-/TUN+(In FM mode)
Press to fine tune decrease/increase the frequency.
Hold down [ TUN-/TUN+] to increase/decrease the
frequency continuously.
10-/10+(In CD mode)
Press this button for each time to increase/decrease
ten tracks.
11 EQ/LED
EQ Press switch the equalizer modes.
LED Hold down this button repeatedly to switch
difference LED light colour modes on the speaker.
12
Open/close the disc tray.
13 SOURCE
Press repeatedly to switch among:
CD-USB-TUNER-LINE IN-BT-CD.
14 REPEAT
Press repeatedly to switch the repeat modes.
15 /
Press to skip to the next track.
Hold down for fast forward playback.
16 RANDOM
Press to switch to the random modes.
17 AUTO/■
Stopplayback.
AUTO(In FM mode)
Hold down to do auto scanning for the
broadcasting radio channels, press it
again to stop auto scanning.
18
Mute or resume volume.

Prepare the Remote control
The Remote Control allows unit to be operated from a distance.
- Even if the Remote Control is operated within the effective range 19.7 feet(6m)inch,remote control
operations may be disrupted if there are any obstacles between the unit and the remote control.
- If the Remote Control is operated near other products that generate infrared rays, or if other remote
control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the
other products may operate incorrectly.
Battery Installation
1. Remove the battery compartment cover on the
back of the remote control.
2. Load one AAA/1.5V battery into the battery
compartment making sure that the battery has
been inserted with the correct polarities
matching the symbols+,- as indicated inside the
battery compartment.
3. Replace the cover.
Precautions Concerning Batteries
- When the Remote Control is not to be used for a long time(more than a
month), remove the battery from the Remote Control to prevent it from
leaking.
- If the battery leak, wipe away the leakage inside the battery compartment
and replace the battery with new one.
- Do not use any battery other than those specified.
- Do not heat or disassemble batteries.
- Keep away from heat or moisture.
- Do not carry or store battery with other metallic objects.
Doing so could cause batteries to short circuit, leak or explode.
- Never recharge a battery unless it is confirmed to be a rechargeable type.

Use a 3.5mm to 3.5mm audio
cable to connect an external audio
device to the LINE IN socket on the
front panel (such as mobile phone,
digital audio player, portable player,
etc.) .
Use the LINE IN Socket
Connect Power
Risk of product damage!
Ensure that the power supply voltage
corresponds to the voltage printed on the
back or the underside of the unit.
-Insert the AC power cord into a mains socket .
Rear panel of the main unit
Speaker Socket
Using the attached speaker wire of satellite speaker connect with the speaker output terminal of
the main unit.
7
( R ) ( L )

Press the SOURCE button on the unit or on the remote control to select the play function CD, USB,
FM, BLUETOOTH, and LINE IN.
Press the VOL+/VOL- button on the remote control or turn the VOL+/VOL- dial on the unit to adjust
the volume.
Press the SOURCE button on the unit or on the remote control to select the LINE IN mode.
8

1 Press the SOURCE on the unit or on the remote control to select Bluetooth mode.
2 The word “BT” will be shown on the display screen, the system has entered pairing mode.
3 Activate your Bluetooth device and select the search mode. “HA450" will appear on your Bluetooth.
4 Select “HA450" in the pairing list, the system is successfully connected and the “BT” keep solid.
5 Begin playing music from the connected Bluetooth device.
CD HI-FI SYSTEM.
CD HI-FI SYSTEM’s
9

1 Insert the USB device.
2 Press the USB button on the remote control or Press the SOURCE on the unit to select the USB
mode.
3 Play starts automatically. If play dose not star automatically, press button.
- To skip to the previous/next track, press the buttons on the remote control or on the unit.
10
1 Press the SOURCE button repeatedly on the unit or press the CD button on the remote control
to select CD mode.
2. Press button on the unit or on the remote control and the disc tray will open.
3 Place the CD/MP3 disc with the label facing up into the CD compartment and press the button
on the unit or on
the remote control to close the disc tray.
- The current playing time of the track will be shown on the display, and the unit will play the first
track on the CD/MP3 disc automatically.
- If there is no disc or the disc can’t be read,”NO DISC”will show on the display.
USB/CD Operation
USB Operation
CD Operation

HA450
Speaker box
Speaker
Unit Net weight
±3dB(20Hz~20kHz)
FM band Range
Frequency response
Unit Dimension(WxHxD)
USB
Power Supply
General
Amplifier(RMS Output power)
3A Battery
Power output (Max)
Power consumption 100W
180WX2
Remote Control
Distance/Angle
Battery Type
Model name
11
433×322×140mm(17.04x12.68x5.51 inch)
3.54kg
3.66kgx2
243×352×240mm(9.57x13.86x9.45 inch)
87.5MHz~108MHz

HA450
Model:MINI HI-FI SYSTEM