HOMCOM 340-005 User manual

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
INffa070_UK
Assembly instructions
● Please check if there are any omissions in the instructions
● Please pay attention to the precautionswhen assembling
340-005

● Accessory name
Knob: 2pcs
Adjustment disc: 2pcs
Adjustment lever: 2pcs Single lever: 1pcsMain shelf: 2parts
Base lever: 2pcs
Scerw: 10pcs+spare 1pc
2

Grip of the horizontal bar
Tighten the knob Tighten the knob
Adjusting lever
Base lever
Base lever
Safety folding lever
Safety port
Adjustment disc
Adjustment disc
To ensure safety, it is recommended that 2 people assemble at the same time.
Open the main shelf, screw on the adjusting disc after unfolding (as shown in the figure)
Safety folding lever
● Way of assembly
● Accessory name
3

Connect the knob and tighten
Tighten the knob
Tighten the knob
Base lever
Base lever
Base lever
Main shelf
Main shelf
● Way of assembly
lmportant: In the direction of the main lever, the tightening knob needs to face the outside,
otherwise the horizontal lever cannot be installed with screws. Connect the accessories and
tighten the screws.
4

Tighten the knob
Adjusting lever
When adjusting, first loosen the knob (the adjusting rod can rotate
freely), then insert the adjusting rod (as shown in the figure), and
turn the knob backward until it can adjust up and down. After the
adjustment is completed, tighten the knob.
Height
Level 1: 88.5cm
Level 2: 102.5cm
Level 3: 115.5cm
Level 4: 129.5cm
● Way of assembly
5

Adjustment guidelines
Adjusting lever
Level of adjustment
Grip of the horizontal lever
Visual tick mark
● Way of assembly
Loosen the knob first, put the adjusting lever into a suitable height and tighten it.
The grip of the horizonta lever is combined with the adjustment bar and locked with screws
Note: The adjustment knob needs to face outwards, if the adjustment knob faces inward, there
will be no corresponding holes.
6

● Height adjustment
Left and right adjustment knobs: Loosen the knobs on the 2 sides first, when the adjustment
lever can be turned, you can adjust the height, and then tighten the knob.
After the adjustment on both sides is at the same height level (there is a scale line on the
adjustment rod, and the scale line shall prevail), after the adjustment rods on both sides are
raised to the same height at the same time, tighten the knob.
Base disc: when there is a gap with the ground, just rotate and adjust to contact with the
ground.
Adjustment disc
7

● Way of folding
Hold the safety folding lever with both hands at the same time, and pull upwards, the equip-
ment can be folded and closed, as shown in the figure
Safety folding lever
Base lever
8