Home Accents Holiday 8 FT GIANT-SIZED LED GIFT BOXES Manual

1006 231 396
1-855-HDHOLIDAY (1-855-434-6543),
Mon-Fri 8am-7pm and Sat from 9am-6pm EST [email protected].
INSTRUCTION MANUAL
SET-UP INSTRUCTIONS FOR THE
8 FT GIANT-SIZED LED GIFT BOXES
STACKED AND UNSTACKED DISPLAY OPTIONS

1
FPO
WARNING: This is not a toy and is for decorative purposes only. For indoor/outdoor use. This item
is not intended for use by children under the age of 14. Do not place product near an open fire or
heat source such as a radiator, stove, etc.
Questions, problems, missing parts? Before returning to your retailer, call our customer service
department at 1-855-HDHOLIDAY (1-855-434-6543), Mon-Fri 8am-7pm and Sat from 9am-6pm
EST or email at [email protected].
PREPARATION: Before beginning assembly of the product, make sure that all parts are present. Compare
parts with package contents list. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement parts.
IMPORTANT: This product can be powered by a UL Listed, 4.5 V, 670mA adapter (included). The adapter
should be plugged into a standard 100V-240V household power outlet.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: “(1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.”
Responsible party for FCC: Pan Asian Creations Limited.
Address: 2560 King Arthur Blvd, Suite 124-26, Lewisville, TX 75056.
For FCC assistance email: [email protected]
KEEP OFF, DO NOT SIT OR CLIMB ON THE GIFT BOXES
THIS IS NOT A TOY. THIS ITEM IS FOR DECORATION ONLY.

SAFETY INSTRUCTIONS:
1. All cautions in these operating instructions should be followed completely.
2. Do not use near water; such as a bathtub, laundry tub, kitchen sink, wet basement or swimming pool, etc.
3. Do not display the product near any heat source such as radiators, stoves, fireplaces, etc.
4. Display should be serviced by a qualified service person only. Do not attempt to service this unit beyond
what is described in the operating instructions.
5. Take extra care when displaying any figure that may contain small parts around small children.
6. Use of this decoration should always be supervised by an adult.
7. Remove AC/DC adapter when not in use.
TO ACTIVATE:
1. Place the product on a water-resistant, level surface.
2. A UL Listed, 4.5Volt 670mA adapter is included with the product. The power adapter needs to be plugged
into a standard 100V-240V household power outlet.
3. The ON/OFF switch is located on the cable. Press switch to the “ON” position to activate LED lights. Press
switch into the “OFF” position and unplug the adapter when not in use.
4. Unplug the power adapter when not in use.
2
Problem Solution
The product
does not work
3. Check to make sure the adapter is connected to a working power source. Make sure the adapter
is plugged into a standard 100V-240V household outlet.
1. Check all wire connections and make sure all parts are securely attached.
2. Check and make sure the ON/OFF switch is in the "ON" position.
TROUBLESHOOTING:
If you are still experiencing problems with the product, please call 1-855-HDHOLIDAY (1-855-434-6543) or email
[email protected] for further assistance.
05202021_2009015
Printed in China
DISTRIBUTED BY:
HOME DEPOT
2455 PACES FERRY ROAD
ATLANTA, GA 30339

A. Left metal connecting support for
gift box 1
B. Middle metal connecting support for
gift box 1
F. Metal connecting support for gift box 2
H. Metal connecting support for gift box 3
C. Right metal connection support for
gift box 1
D. Base
I. Gift box 3G. Gift box 2
J. Free spinning washer nut (for gift box 3) K. Gift boxes 4 (set of 2) L. AC/DC adapter
M. Cable (for unstacked display)
X 1 X 1 X 1
X 1 X 1 X 1
X 1 X 1 X 1
X 1 X 1
X 1 X 4 X 1
3
N. Ground Stakes
E. Gift box 1 (with ON/OFF Switch Cable)
PART LIST

Step 2
Step 1
Step 3
A
A
D
C
C
BB
LOCKING PIN MEANS IT’S LOCKED
“CLICK”
ASSEMBLY:
4
D
N
N
D
Insert 4 x ground stakes (N) through the
corresponding holes located in the base (D)
and push or gently hammer (not included) to
secure into the ground for outdoor display
stability as shown.
NOTE: For outdoor yard display it is recommended that you start the assembly process by first determining the intended display location,
making sure that the surface is flat and/or level for the placement of the base, and then securing the base firmly into the ground with the
included ground stakes.

Step 4
Step 6
Step 5
E
F
G
E
5
Unplug the DC jack cover
Unplug the DC jack cover
Connect the cable from the bottom of
gift box 2 (G) into the DC jack on the top
of gift box 1 (E)
Step 7

Step 8 Step 9
I
H
Step 10
6
I
J
H
Connect the cable from the
bottom of gift box 3 (I) into the
DC jack on the top of gift box 2
(G)
Tighten the free spinning washer nut (J)
onto the top end of the metal connecting
support for gift box 3 (H) to secure gift
box 3 (I) into place.

L
Step 13
Step 12
7
Connect the cable from the bottom of
gift boxes 4 (K) into the DC jack on the
top of gift box 3 (I)
Step 11
Fully Assembled Product
K
E
L
I
O
I
Once the power supply has been plugged
in, toggle the ON/OFF switch located on
the cable of gift box 1 (E) to the “ON”
position to activate LED lights.
Connect the UL-Listed, 4.5V 670mA
AC/DC Adapter (L) into the connection at
the end of the ON/OFF switch cable of gift
box 1 (E), and plug it into a standard
100V-240V household power outlet.

8
Step 15
Step 16
Plug the DC jack covers into
the DC jacks located at the
tops of gift box 1 (E) and gift
box 2 (G)
UNSTACKED DISPLAY OPTION
G
E
I
K
O
I
Connect the cable from the bottom of gift
boxes 4 (K) into the DC jack on the top of
gift box 3 (I)
Connect the ends of cable (M) into the end of
the cable of gift box 1 (E), gift box 2 (G), and
gift box 3 (I)
Step 14
Step 17
Once the power supply has been plugged in, toggle
the ON/OFF switch located on the cable of gift box
1 (E) to the “ON” position to activate LED lights.
Connect the UL-Listed, 4.5V 670mA AC/DC Adapter (L)
into the connection at the end of the ON/OFF switch
cable of gift box 1 (E), and plug it into a standard
100V-240V household power outlet.
K
I
I
K
M
L