HOMEDEPOT 32"W BOOKCASE User manual

ASSEMBLY INSTRUCTION
E460-12 32"W BOOKCASE
1
AC
B D
EG
F
1pc 1pc
Top Panel Upper Shelf Middle Shelf
1pc
This page lists all the contents included in
the box. Please take the time to identify
the hardware as well as the individual
components to this product. As you
unpack and prepare for assembly, place
the contents on a carpeted or padded
area to protect them from damage.
Lower Shelf
Left Side Frame
1pc
Bottom Shelf Right Side Frame HCross Bar
2pcs
I K
J
16pcs11pcs
Hex Nut
1pc
L
MN
1pc
Spanner Anti-Tipping Kit
2sets
1pc
1pc 1pc
Bolt
Ø1/4"x5/8"
Bolt
Ø1/4"x7/8"
Allen Key
M4
1pc

2
1Attach Upper Shelf (B), Middle Shelf (C), Lower Shelf (D) and Bottom Shelf (E) to
Left Side Frame (F) & Right Side Frame (G) using Bolt (J) by Allen Key (L) as below
shown.
2Attach Top Panel (A) to Left Side Frame (F) & Right Side Frame (G) using Bolt (I) by
Allen Key (L) as below shown.
B
D
C
E
F
L
G
J
G
F
A
LI

H
K
M
L
H
I
H
3
3Secure both Cross Bar (H) together using Bolt (I) and Hex Nut (K) as shown. While
holding Hex Nut (K) with Spanner (M), tighten Bolt (I) by Allen Key (L) as below
shown.
4Attach Cross Bar (H) to the back of Left Side Frame (F) & Right Side Frame (G),
using Bolt (I) by Allen Key (L) to lock the bottom holes of Cross Bar (H) first only as
below shown.
L
G
H
I
F

4
5
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant.
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware
may loosen over time. Periodically check that all connections are tight.
Wall
Wall
2
1
I
A
N
L
*NOTE: WE RECOMMEND THAT YOU ATTACH THE PRODUCT TO YOUR
WALL AS A SAFETY PRECAUTION USING ANTI-TIPPING KIT (N) AS
BELOW INSTRUCTION.
Attach 2pcs mounting plate of Anti-Tipping Kit (N) to the top holes on back of
Back Cross Bar (H) using Bolt (I) by Allen Key (L), making sure the Mounting
Plate extend DOWNWARD.
Drill 2 holes in your wall approximately 2” (Inches) BELOW the corresponding
positions of Mounting Plate and insert Wall Anchor as shown.
* NOTE: You may need to tap LIGHTLY with a rubber mallet.
Now connect the corresponding Mounting Plate with Connection Strap and
tighten as described before locking in place.
N
Wall
3
4
Wall