HOMEDEPOT T-36RP User manual

ITEM NO : T-36RP
REVISED MAR 07, 2015 Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: 36 IN ROUND PED TABLE
: T-36RP

ITEM NO : T-36RP
REVISED MAR 07, 2015 Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1 B Center leg 1
C Right leg 1 D Left leg 1
E Mounting
plate 1
F Wood slide 2

ITEM NO : T-36RP
REVISED MAR 07, 2015 Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Long Bolt
(M6x100mm) 2
2
Lock washer
(6.5x11mm)
14
3
Small Flat
washer
(6.5x13mm)
6
4
Large Flat
washer
(6.5x19mm)
8
5 Short Bolt
(M6x45mm) 12
6 Allen key
(M4x80mm) 1
7 Wood button
(14.5mm) 2
STEP 1
Attach right leg (C) to the center leg (B) and left leg (D) with Long bolts (1) and washers (2) and (3),
as shown below. Tighten with the Allen key (6).

ITEM NO : T-36RP
REVISED MAR 07, 2015 Printed in Vietnam
- 4 -
STEP 2
Place the plate on top of the pedestal (E), attach with short bolts (5) , and washers (2) and (3) as
shown below. Tighten with the Allen key (6).
Insert the wood slides (F) into the groove of the mouting plate.
STEP 3
Carefully place the base (from step 2) on the bottom side of the top (A). Attach the mounting plate
to top (A) with short bolts (5) and washers (2) and (4). Tighten with Allen key (6).

ITEM NO : T-36RP
REVISED MAR 07, 2015 Printed in Vietnam
- 5 -
STEP 4
Insert wood buttons (7) over bolts to cover them.
Hold the dropleaf push and slide the wooden piece from underneath the table top. To lower the dropleaf,
carefully hold the dropleaf with one hand and slide the wooden piece from underneath the table top towards
the center of the top. Then, gently lower the leaf and place in the down position.