HoMedics enviraScape SIENA WFL-SIEN Instruction Manual

Instruction Manual and
Warranty Information WFL-SIEN
ILLUMINATED TABLETOP RELAXATION FOUNTAIN
© 2005 HoMedics, Inc. and its affiliated companies, all rights reserved. HoMedics®is a
registered trademark of HoMedics, Inc. and its affiliated companies. Envirascape™ is a
trademark of HoMedics, Inc. and its affiliated companies. All rights reserved.
IB-WFLSIEN
ONE YEAR LIMITED WARRANTY
(Valid in USA only)
HoMedics, Inc., guarantees this product free from defects in
material and workmanship for a period of one year from the date
of purchase, except as noted below.
This HoMedics product warranty does not cover damage caused
by misuse or abuse; accident; the attachment of any unauthorized
accessory; alteration to the product; or any other conditions
whatsoever that are beyond the control of HoMedics. This
warranty is effective only if the product is purchased and
operated in the USA. A product that requires modification or
adaptation to enable it to operate in any country other than the
country for which it was designed, manufactured, approved
and/or authorized, or repair of products damaged by these
modifications is not covered under warranty. HoMedics shall not
be responsible for any type of incidental, consequential or special
damages. All implied warranties, including but not limited to those
implied warranties of fitness and merchantability, are limited in the
total duration of one year from the original purchase date.
To obtain warranty service on your HoMedics product, either hand
deliver or mail the unit and your dated sales receipt (as proof of
purchase), postpaid, along with check or money order in the
amount of $5.00 payable to HoMedics, Inc. to cover handling.
Upon receipt, HoMedics will repair or replace, as appropriate,
your product and return it to you, postpaid. If it is appropriate to
replace your product, HoMedics will replace the product with the
same product or a comparable product at HoMedics’ option.
Warranty is solely through HoMedics Service Center. Service of
this product by anyone other than HoMedics Service Center voids
warranty.
This warranty provides you with specific legal rights. You may
have additional rights which may vary from state to state. Because
of individual state regulations, some of the above limitations and
exclusions may not apply to you.
For more information regarding our product line in the USA,
please visit: www.homedics.com
Mail To:
HoMedics
Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390
e-mail:
cser[email protected]
phone:
800-466-3342
SIENA
R
TM
WFL-SIEN_6.qxd 1/9/06 8:55 AM Page 1

The soothing sounds of nature
Thank you for purchasing EnviraScape, HoMedics’ tabletop
relaxation fountain. This, like the entire HoMedics product line,
is built with high-quality craftsmanship to provide you years of
dependable service. We hope that you will find it to be the finest
product of its kind.
EnviraScape enables you to create an all-encompassing
environment with sound. The sound of flowing water enhances
your environment by releasing negative ions, and promoting
relaxation. Only EnviraScape offers you the luxury of these vital
benefits with its creative design which adds beauty to any indoor
environment.
EnviraScape Features
• Innovative, artistic design enhances the environment at
home or at work.
• Special effect lighting illuminates fountain for a more
dramatic effect.
• The soothing sound of cascading waters create a stress
free ambiance.
• Improves concentration by masking distractions so you
can stay focused.
• Durable electrical water pump can be operated from any
indoor electrical outlet.
• Convenient tabletop size-fountain measures
10.25"L x 4.5"W x 15.25"H.
IMPORTANT SAFETY INSTRUCTIONS:
When using an electrical appliance, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
DANGER - To reduce the risk of electric shock:
• Always unplug the appliance from the electrical outlet
immediately after using and before cleaning.
• Do not reach for an appliance that has fallen into water.
Unplug it immediately.
•
Do not place or store appliance where it can fall or be pulled into
a tub or sink. Do not place in or drop into water or other liquid.
• Do not connect to any voltage other than that shown on the pump.
• Do not pump flammable liquids.
• Do not use water above 86oFahrenheit .
2
WARNING - To reduce the risk of burns, fire, electric shock or
injury to persons:
• An appliance should never be left unattended when plugged in.
Unplug from outlet when not in use and before putting on or taking
off parts or attachments.
• Close supervision is necessary when this appliance is used by or
near children, invalids or disabled persons.
• Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by HoMedics;
specifically any attachments not provided with the unit.
• Never operate this appliance if it has a damaged cord, plug, pump,
cable or housing. If it is not working properly, if it has been
dropped or damaged, return it to Homedics Service Center for
examination and repair.
• Keep cord away from heated surfaces.
• Never drop or insert any object into any opening.
• Do not operate where aerosol (spray) products are being used
or where oxygen is being administered.
• Do not carry this appliance by power cord or use cord as handle.
• To disconnect, remove plug from outlet.
• This appliance is designed for indoor use only.
Do not use outdoors.
SAVE THESE INSTRUCTIONS
Caution – Please read all instructions carefully
before operating.
• Never leave the appliance unattended, especially if children
are present.
• Never cover the appliance when it is in operation.
• This unit should not be used by children without
adult supervision.
• Connect the pump with the proper voltage as indicated
on the pump label.
• Always keep the cord away from high temperature and fire.
• Unplug the pump from power source before cleaning,
maintenance or disassembling.
• To get the best flowing effect, product must be placed on a flat
surface and should never be placed on an electrical appliance.
• Never let pump run dry, as this will shorten life of the pump.
• Do not lift, carry, hang, or pull the pump by the power cord.
• Operate with tap or distilled water only.
• Operate pump completely submerged for proper cooling.
• The electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using this product immediately and return
it to the HoMedics Service Center for repair. (See the warranty
section for HoMedics address.)
• Disconnect the appliance from outlet before putting hands
into water.
3
CAUTION:
The pump must
be completely
submerged in
water. If the
pump is
making noises,
most likely it is
not completely
submerged in
water.
CAUTION:
Only set the
fountain and
fountain parts
on waterproof
surfaces
WFL-SIEN_6.qxd 1/9/06 8:55 AM Page 3

Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch
located at the front of the pump. The speed is indicated by a plus (+) and minus
(-) sign. To increase the speed, move the switch slowly downward in the direction of
the plus sign. You will hear a click as the switch moves to each speed level. At its
highest speed level, the switch will cease to move any further. To decrease the pump
speed, move the switch upward toward the minus sign. Similarly, at its lowest speed,
the switch will cease to move any further (Fig 1).
NOTE: It is recommended the pump be set at its highest speed during assembly
and later adjusted to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
3. Insert the rubber end of waterproof light into the light clip located inside the
base. (Fig.2) Slight twisting may help to push the rubber end through the
clip more easily.
Note: Be gentle with the bulb cover since it is made of glass.
4. Lead the power cord up through the cord slot located on the back
wall of the base. (Fig. 3)
5. Insert the plastic tube attached to the fountain top through the tube slot
located on the back wall of the base. (Fig. 4)
6. Be sure the fountain top is sitting level on the base and then secure down
using screws. (Fig. 4)
Note: You will need a Phillips screwdriver to assemble. (Not Included)
7. Insert the black connector at the bottom of the plastic tube into the round
opening of the pump. (Fig. 5)
8. Fill the base with clean water until the water level reaches 2 inches deep.
(Fig. 6)
9. Place the screen on the support tabs of base, using the
handling tab. (Fig. 7)
10. Attach the A/C adapter jack to the base power cord. (Fig. 8)
11. Plug the cord into 120V household outlet. The fountain is controlled by a
switch located on the power cord. If pump does not operate, rotate in-line
switch once to turn “on” and once to turn “off”.
Note: Ensure that the electrical cord loops below the electrical outlet to
form a “Drip Loop”. This will prevent water from running down the
electrical cord into the electrical outlet. (Fig. 9)
Minimum Water Level
Flow Control Valve
(+) faster water output
(-) slower water output
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
Figure 1
4 5
Figure 2 Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Power Cord
Pump
Pump
Cord Slot
PowerCord
Light Clip Waterproof Light
Pump
Plastic Tube
Base
Base
Screen
Support
Tabs
Screen
To p
Screw
Water
Plastic Tube
Tube Slot
Handling
Ta b
AC Adapter
WFL-SIEN_6.qxd 1/9/06 8:55 AM Page 5

ILLUMINATED TABLETOP RELAXATION FOUNTAIN
7
6
• Changing Light Bulb
First unplug fountain and let bulb cool down. Remove the bulb cover by
holding glass bulb cover in dry hand and rubber neck with other hand.
Slowly pull apart. Slight twisting may help to loosen. Be gentle with bulb
cover since it is glass. Never pull on cord. Next, pull bulb straight out and
replace with new bulb, inserting prongs into the holes.
Replace bulb cover securely.
Troubleshooting
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make
sure the pump is getting electrical power.
NOTE: Always disconnect from electrical outlet
before handling the pump.
• If the pump gurgles, spews, or “burps”:
Check the water level to make sure the pump has enough
water to function.
•Obtaining a desired water level:
Check the water level daily the first week to measure the rate
of evaporation; refill with water as needed.
•If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on the pump.
Caution:
All servicing
of this fountain
must be
performed
by authorized
HoMedics
service
personnel only.
Drip Loop
Figure 9
Maintenance
• To clean the pump:
Unplug from electrical outlet. Remove it from the base of the fountain.
Use a small brush or stream of water to remove any debris (Fig 10).
• To keep water clean:
Periodically change water and clean the product according to the water
condition. Keeping the water clean prevents the water from becoming
sticky and forming micro-organisms. We recommend distilled water to
prevent mineral build-up.
• To clean off hard water deposits on the base:
Soak the container in a mixture of vinegar and water to clean and
remove any mineral build-up.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid
shortening the life of the pump.
NOTE: Never let the pump run dry, as this will shorten
the life of the pump.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water, and store
fountain in a dry, cool place.
Figure 10
Front Plate
PVC Tubing
Inserts Here Back Plate
Suction Feet
Impeller
Pump Inlet
Flow
Control
Lever
Housing
PP-WFLBULB2 Replacement bulbs and covers for $5.00
WFL-SIEN - pack of 5
SUBTOTAL
TAX-Michigan Residents add 6%
Total
Name
Address
City State Zip Code Phone Number
( )
Detach and return order form with check or money order payable to HoMedics, Inc.
Please allow 2 to 4 weeks for delivery.
Replacement Parts Order Form
PART DESCRIPTION QUANTITY COST
SIENA
TM
Mail To:
HoMedics
Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI 48390
e-mail:
[email protected]
WFL-SIEN_6.qxd 1/9/06 8:55 AM Page 7