HomePlus H+H User manual

HEAT SYSTEM
GUIDE & USER MANUAL
HEATER CONTROLLER H+H |REMOTE CONTROLER H+R
HEATER
CONTROLLER
–
HORIZONTAL
+
REMOTE
CONTROLLER
IH+hUK1712

SAFETY:
1. The heater should be installed by a qualied person.
2.Bathroom radiators tted with electric heaters should be xed not less than
60cmfromabath,showerorwashbasin,andneveraboveabath.
3.Fortheheaterpermanentlyconnected(hardwire)theremustbeappliedacut-off
devicefromthemains.Suchadevicemustdisconnecttheheaterfromthesupply
mainsin2poles,withcontactseparationofatleast3mm.
4.Thisappliancecanbeusedbychildrenagedfrom8yearsandaboveandpersons
withreducedphysical,sensoryormentalcapabilitiesorlackofexperienceand
knowledgeiftheyhavebeengivensupervisionorinstructionconcerninguseof
theapplianceinasafewayandunderstandthehazardsinvolved
5.Childrenshallnotplaywiththeappliance.Cleaningandusermaintenanceshall
notbemadebychildrenwithoutsupervision.
6.Oneradiatorvalvemustalwaysbeopenwhenaheaterisinuse
 (liquidthermalexpansion).
ThisequipmentrequiresRCDprotectionwithratedresidualoperating
currentnotexceeding30mA.
Thisequipmentmustbeconnectedtocircuitprotectiveconductor(earth).
CAUTION:Toavoidtheriskofreorelectricshocktheheatershouldbeprotectedfromwatersprayorooding.
Exclamationmarkontriangulareldsignals:information important for the user.
GUARANTEE TERMS:
Guaranteeisgrantedbymanufacturerfor24monthsperiodstartingfromdateofsale,butnolongerthan36monthsfromdateoftheheat-
ermanufacture.Defectsrevealedwithinthisperiod,resultingfromafaultofmanufacturerwillberepairedfreeofchargeortheitemre-
placedwithnew,equivalentone.Termofcomplaints’investigationupto14(fourteen)daysfromdateofsubmissiontothemanufacturer.
Guarantee does not cover:
1.Usingofproductinamannernoncompliantwithattachedinstructions.
2.Anyvisibledamagetotheheatingelementorcontrollerduetoimproperuse.Damagingofmanufacturer’ssealsmakes
theguaranteenullandvoid.
In the event that Heatpol are unable to repair or replace this product we reserve the right to refund the purchase price as an alternative.
GUARANTEE CARD
Serial No.:
Date of sale:
Stamp of retail outlet, signature of seller
Caution: Theguaranteecardshouldbelegiblylledinretailoutlet.Anycorrectionsontheguaranteecardwillinvalidate
theguarantee.Guaranteecardvalidonlywithproofofpurchase.
Mników 322, 32-084 Morawica, Poland
Tel/fax: [phone]
Watch video instruction for heater controller at:
www.homeplus-system.com

Electricradiatormustbe
equippedwithasafetyvalve
Side connection
Kit content
Mounting in radiators CH system Electric radiators
Heater
controller
Heatingelement
Right side Left side
Heating element Heating element
Allen
key
USER MANUAL: Heating element + Heater controller (horizontal) H+H
180˚
180˚
+
_
System option:
Remotecontroller
Wallclip
Installationdetails
2
S24
230 V
LOCTITE
Priortoscrewingtheheatingelementin,
spreadtheLoctitesealant(included)
overthethreadsurface,
onthehalfofitscircumference.
1
min. 25mm
Specialsiliconegasket
ontheheadensures
tightnesswithout
needforexcesive
tightening.

3-5cm
5A
Electricradiators CHsystem
5B
230 V
CAUTION! Do not disconnect heater
controller when the system is powered.
The locking screw must be protected against
accidental unscrewing eg. by applying a drop
of lacquer or acrylic adhesive.
15 cm
3
4
How to Hard Wire
Live
Earth
Neutral
23 0V
6B
6A
23 0V
7
For the heater
permanently
connected (hard wire)
there must be applied
a cut-off device from
the mains.
Such a device must
disconnect the heater
from the supply mains
in 2 poles, with contact
separation of at
least 3 mm
Connection with a coiled
cable and a plug
Hard wire connection
After electic connection
please turn the switch ON

Pairing button
for allen key (F)
Back
Magnet clip Wall clip
mounting
USER MANUAL: Howtouse heater controller(optionalremotecontroller)
VIDEOavailableatwww.homeplus-system.com
Connect heater controller to the heater
Use manufacturer recommendation
Turn ON the controller
ON/OFF
Heatercontroller
Remotecontroller
TURBOmodeactivation
3
sec
–
+
3
sec
5
sec
1
+
–
2
3
Heater
controller
display
LED (Activity)
Heatercontroller Remotecontroller
Run the controller
Hold upper button
for 3 seconds
Switch off the controller
Hold lower button
for 5 seconds
40˚C
Standard heating
temperature
+
–
10˚C - 65˚C*
Select temperature
Max heating temperature, selection for 1/2/3 hours
Off selection
TURBO mode activation - max heating temperature
Hold button for 3 seconds
LED activity: heating element is working
Push for pairing button using allen key
to activate the controller.
Locate suitable place to mount the clip
When switched to an ambient temperature control,
a remote controller is simultaneously
a temperature sensor
Allenkey
* maximum temperature can be different
according to the producer settings

DO NOT DISCONNECT!
controllerfromheatingelement,whenconnectedtothepowersupply
Errors
Settingswaterorambienttemperature Errors
1x
1x
3
sek
2x
2x
+
–
During countdown
within 30 seconds
Reverse remote controller.
Push pairing button!
Pairing nished!
Remote controller
is already working
Allen key
included
Hold 3 sec.
Start countdown
Press once
upper and lower
button together
Press twice
upper and lower button
together
Temperature selection.
Water temperature
Ambient temperature
This function is available
if heater controller is paired
with remote controller Lack of water (or wrong choice of
heating element to the heater)
Damaged heating element
(or no power cuircit)
No communication to the remote
controller if paired
Prepare remote controller + allen key for use
Heater controller and remote controller pairing
Ifyouboughtthepilotcompletedtoaheater—theremotecontrollerisalreadypaired!
Remote controller is an
ambient temperature sensor
*

Connect heater controller to the heater
Use manufacturer recommendation
Turn ON the controller
ON/OFF
Heatercontroller
Remotecontroller Push for pairing button using allen
key to activate the controller.
Locate suitable place
to mount the clip
When switched to an ambient temperature
control, a remote controller is simultaneously
a temperature sensor
USER MANUAL: Howtouseremote controller(tocontroltheheatercontroller)
–
+
START:Heatercontrollerandremotecontrollerpairing
Ifyouboughtthepilotcompletedtoaheater—theremotecontrollerisalreadypaired!
1
Remotecontroller
Heater
controller
display
LED (Activity)
Heatercontroller
Pairing nished!
Remote controller
is already working
Allen key
included
1x
1x
3
sec During countdown
within 30 seconds
Reverse remote controller.
Push pairing button!
Hold 3 sec.
Start
countdown
Press once
upper and lower
button
Prepare remote controller + allen key for use
Pairing button
for allen key (F)
Back
Magnet clip Wall clip
mounting
Allenkey

Settingswaterorambienttemperature
2x
2x
+
–
2 3
3
sec
5
sec
Run the heater controller
via remote controller
Hold upper button
for 3 seconds
Switch off the controller
via remote controller
Hold lower button
for 5 seconds
40˚C
Standard heating
temperature
+
–
10˚C - 65˚C*
Select temperature
3
sec
+
–
Max heating temperature, selection for 1/2/3 hours
Off selection
TURBO mode activation - max heating temperature
Hold button for 3 seconds
Press twice
upper and lower
button
Temperature selection.
Water temperature 10-65˚C*
Ambient temperature 10-30˚C
TURBOmodeactivation
4
Remote controller is an
ambient temperature sensor
* maximum temperature can be different
according to the producer settings