HomeSpot JY100 User manual
HomeSpot JY100
®
Wireless Neckband Headphones
User Guide
User Guide
Warranty Card
Ear Tips (S, L)
Note: The size M ear tips are
pre-installed on the JY100.
Micro-USB Charging Cable
Package Contents
HomeSpot JY100
Wireless Neckband Headphones
Volume +
Volume -
Microphone
Multi-Function
Button (MFB)
LED Indicator
L (Left)
R (Right)
Product Overview
Charging & Battery Status
We recommend charging the HomeSpot JY100 with a 5V 500mA or 5V
1A USB power source. Power adapters or chargers that supply more
than 5.5V will damage the JY100 and should not be used.
It takes up to 3 hours to fully charge a JY100 and it can
provide about 8 hours of listening time.
20 minutes of charging gives about 1 hour of listening time.
To check the JY100 battery level, press the Volume +/- key when the
JY100 is idle (not on a call or music playing).
When battery level is below 10%, there will be a periodic warning tone
and the LED indicator will ash in red.
Step 2
LED indicator will be red when
charging, and will be off when
the JY100 is fully charged.
Step 1
Using the micro-USB cable,
connect the JY100 to a
USB power source.
Pairing
1. With the JY100 turned off, press and hold the MFB key until you hear
the “Pairing” voice prompt and the LED indicator starts ashing red and
green.
2. Turn on the Bluetooth function on your mobile device, search for and
pair with “HomeSpot JY100”.
3. Once paired, you will hear the “Connected” voice prompt and the LED
indicator will be green.
4. Next time when turning on the JY100, it will try to re-connect to the
previously paired device.
Controls
Power on
Power off
Play/pause music
Answer/end call
Reject call
Activate voice
assistance
(Siri, OK Google)
Set JY100 to
pairing mode
Press and hold the MFB key for 1 second
Press and hold the MFB key for 4 seconds
Press the MFB key during music playing
Press the MFB key during call
Double press the MFB key
Press and hold the MFB key for 1 second
when not on a call
Turn off JY100, then press and hold the
MFB key for 4 seconds
Reset JY100 Turn off JY100, then press and hold the
MFB key for 7 seconds, JY100 will go into
pairing mode after reset
Adjust volume
Next/Previous song
Check battery level
Mute microphone
Un-mute
microphone
Press the Volume +/- key during call or
music playing
Press and hold the Volume +/- key for
1 second during music playing
Press the Volume +/- key when the JY100
is idle (not on a call or music playing)
Press and hold the Volume - key for
1 second during call
Note: There will be a periodic reminder tone
when microphone is muted
When microphone is muted, press the
Volume +/- key to un-mute
Troubleshooting
Problems Suggestions
The JY100 does not turn on The battery level is too low, charge the JY100
Poor audio quality Reduce the distance and remove obstacles
between the JY100 and the paired mobile
device
Cannot pair the JY100
with my mobile device
Make sure the JY100 is not already connected to
another device
Make sure the JY100 is in pairing mode, LED
indicator should be ashing red and green
If the mobile device has previously paired with
the JY100, remove the JY100 pairing record,
then re-do the pairing procedure
Turn off the JY100, then re-do the pairing
procedure
Reset the JY100
Specications
Bluetooth Version
Codec
Prole
Effective Range
Play Time
Input Power
Charging Time
5.1
SBC, AAC, aptX, aptX Low Latency
A2DP, AVRCP, HFP, HSP
10 meters (30 feet)
8 Hrs
5V 500mA
3 Hrs
WARNING: Due to the isolating characteristics of these headphones do not use while
driving, riding a bike or where vehicular traffic is present, or in any other activity where
failure to hear surrounding sounds could be dangerous. Use of these headphones at
excessive volumes may cause permanent hearing damage. Always turn the volume down
before use. Take caution in regards to inserting objects into ear canal, use at own risk.
COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow-
ing measures:
– Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment must not be co-located or operated in conjunction with any other antenna or transmitter.
TRADEMARK
- Siri is a trademark of Apple Inc., registered in the U.S. and other countries.
- OK Google is a trademark of Google LLC.
- The Bluetooth® word mark and logos are owned by Bluetooth SIG, Inc. and any use of
such marks by HomeSpot® is under license.
- Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
- Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and
other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., regis-
tered in the United States and other countries.
20211215_HP_JY100_EN
Table of contents
