Honeywell Honeywell Thermostat PRO TH3000 Series User manual

This martua| covers the following modets:
TH3110D: For 1Heat/1 Cool systems
TN3210D: For 2 Heat/1 Cool heat pump systems only
(Pull thermostat from wallplate and turn over to find model number.)
CAUTION: EQUIPMENT DAMAGE HAZARD,
To prevent possible compressor damage, do not operate cooling system when outdoor
temperature is below 50°F (10°C).
For assistance with this product please Visithttp://yourhemeLhoneyweH.eom
oroa! IHoneywel! Customer Care toil-free at 1_800.468_1502
Read and save these instructions,
® U.S. Registered Tredemark. Patents pending.
Copyright ® 2006 Honeywell International Inc. All rights reserved.

PRO TH3110D / TH3210D
About your new thermostat
Thermostat features ................................... 2
Quick reference to controls ....................... 3
Quick reference to display ........................ 4
Thermostat Operation
System switch (Heat/Cool) ........................ 5
Fan switch (Auto/On) ................................. 6
Temperature controls ................................. 7
Compressor protection .............................. 8
Appendices
Battery replacement .................................. 9
In case of difficulty ................................... 10
Customer assistance ............................... 12
Accessories .............................................. 12
5-year limited warranty ............................ 13

Operating Manual
!
Your new Honeywell thermostat has been designed to give you many years of reliable
service and easy-to-use, push-button climate control.
Features
• Large, clear, bacMit display is easy to read, even in the dark.
Displays both room temperature and temperature setting.
Built-in compressor protection.

PRO TH3110D / TH3210D
- i
Digita| display screen Temperature adjustment
page 7)
Fan Switch (see page 6)
On: Fan runs continuously.
Auto: Fan runs only when heating or
cooling system is on,
System switch (see page 5)
oCool: Cooling system control.
•Off; All systems off,
•Heat: Heating system control,
•IEm Heat =Emergency & Auxiliary
Heat control. Compressor is locked
out, (Select models only,)

Operating Manual
Current inside temperature Temperature setting
Low battery warning
(see page 9)
System Status
•Cool On: Cooling system is on.
• Heat On: Heating system is on.
•Ern: Emergency heat is on. **
•Aux: Auxiliary heat is on. **
** Only for heat pumps with this capability
(select models only).
4
tf "Heat On" or "Cool
On" is flashing, com-
pressor protection is
engaged (see page 8).

PRO TH3110D / TH3210D
The SYSTEM switch can be set to control
your heating or cooling system, depending
on the season.
Coop Cooling system control.
• Off: All systems are off.
• Heat: Heating system control.
• IEm Heat" Emergency & Auxiliary Heat
control. Compressor is locked out.
(Select models only.)
Set SYSTEMswitch to control the
heating or cooling system. CAUTION: EQUIPMENT DAMAGE HAZARD,
Do not operate cooling system when outdoor
temperature is below 50°F (10°C).

Operating Manual
r'1
i
Set the FAN switch to Auto or On.
In "Auto" mode (the most commonly used
setting), the fan runs only when the heat-
ing or cooling system is on.
If set to "On," the fan runs continuously.
Use this setting for improved air circula-
tion, or for more efficient air cleaning.
Set FAN switch to choose whether the fan
runs continuously or only as needed.

PRO TH3110D / TH3210D
Press the temperature adjustment
buttons until the temperature you want
is displayed in the upper right portion of
the screen.
Note: Make sure the SYSTEMswitch is set
to the system you want to control (Heat or
Cool),
temperature, adjustment buttons.

Operating Manual
i !
Message flashes
time has elapsed.
This feature helps prevent damage to the
compressor in your air conditioning or heat
pump system.
Damage can occur if the compressor is
restarted too soon after shutdown. This fea-
ture forces the compressor to wait 5 minutes
before restarting.
During the wait time, the display will flash
the message Cool On (or Heat On if you have
a heat pump). When the safe wait time has
elapsed, the message stops flashing and the
compressor turns on.

PRO TH3110D / TH3210D i
Pull at bottom to
remove thermostat
from wallplate. \
Turn thermostat over,
insert fresh AA alka-
line batteries, then
reinstall thermostat.
Batteries are optional (for backup
power) if your thermostat was wired to
run on AC power when installed.
Install fresh batteries when the REPLAOE
BATT warning begins flashing. The
warning flashes about two months
before the batteries are depleted.
Replace batteries once a year, or
before leaving home for more than a
month. Batteries provide backup power
to the display during power interrup-
tions. All settings are permanently
stored in memory, and do not require
battery power.

Operating Manual
I _ _ 0 0 |
If you have difficulty with your thermostat, please try the following suggestions.
Most problems can be corrected quickly and easily.
Display is blank • Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• Make sure fresh AA alkaline batteries are correctly installed (see page 9).
Heating or
cooling system
does not respond
• Set system switch to Heat (see page 5). Make sure the temperature is
set higher than the Inside temperature.
• Set system switch to Cool (see page 5). Make sure the temperature is
set lower than the Inside temperature.
• Wait 5 minutes for the system to respond.
10

PROTH3110D/ TH3210D
I _ _ 0 0 |
Temperature Make sure heating and cooling temperatures are set to acceptable ranges:
settings de net • Heat: 40° to 90°F (4.5° to 32°C).
change • Cool: 50+to 99°F (10°to 37°C).
"CooJ On" Or
"Heat On" is
flashing
• Compressor protection feature is engaged. Wait 5 minutes for the system
to restart safely, without damage to the compressor (see page 8).
+=Heat On" is not • Set the System switch to Heat, and set the temperature level above the
displayed current room temperature (see page 7).
"Cool On" is net • Set the System switch to Cool, and set the temperature level below the
displayed current room temperature (see page 7).
11

OperatingManual
"_ j
Pull at bottom to For assistance with this product, please visit
remove thermostat http://yourhome,honeyweH,com.
Or call Honeywell Customer Care toll-free at
1=800=488= 1502.
To save time, please note your model number
and date code before calling.
and date code. Accessories/replacement parts
To order, please call Honeywell Customer Care
toll-free at 1=800=488-1502.
Cover plate assembly*. ....... Part No. 50002883-001
*Use to cover marks left by old thermostats.
12

PROTH3110D/ TH3210D
Honeywell warrants this product, excluding battery, to be free from defects in the workmanship
or materials, under normal use and service, for a period of five (5) years from the date of pur-
chase by the consumer. If at any time during the warranty period the product is determined to
be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell's option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the place from which you pur-
chased it; or
(ii) call Honeywell Customer Care at 1-800-468-1502. Customer Care will make the determination
whether the product should be returned to the following address:
Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr. N., Golden Valley, MN 55422, or
whether a replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it
is shown by Honeywell that the defect or malfunction was caused by damage which occurred
while the product was in the possession of aconsumer.
Honeywell's sole responsibility shall be to repair or replace the product within the terms stated
above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND,
13

OperatingManual
INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR
INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY
OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY tS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS
PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO
THE FIVE-YEAR DURATION OF THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so the above limita-
tion may not apply to you. This warranty gives you specific legal rights, and you may have other
rights which vary from state to state.
If you have any questions concerning this warranty, please write Honeywell Customer Relations,
1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502. tn Canada, write Retail
Products ON15-02H, Honeywell Limited/Honeywell Limitee, 35 Dynamic Drive, Scarborough,
Ontario MlV4Z9.
14

Automation and Control Systems
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limit_e
35 Dynamic Drive
Scarborough, Ontario MlV 4Z9
http://yourhome,honeywell,com
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
® U.$. Registered Trsdemark.
© 2006 Honeywell International Ino.
69-1776E8-1 M.$, Rev, 04-06
Heneywe|!